Your cart is empty.
Your cart is empty. Please confirm the (Size Voltage Current) before order.
Designed with 0.2 x 0.79 inch / 5 x 20mm Ceramic tube, 10A 250V breaking current.
A type of low resistance resistor that acts as a sacrificial device to provide
overcurrent protection, of either the load or source circuit.
With overload and overcurrent protection.
Widely used for electric equipment, home applicance, ans so on.
Joe
Reviewed in the United States on February 14, 2025
These got my multi-meter back in business quickly. Seem to be a perfect replacement for the original fuse!
Mr Mac
Reviewed in the United States on January 13, 2025
No issues. Worked in A/C unit.
Ogden Utah
Reviewed in the United States on September 8, 2024
Great product to keep thing working with plenty of back ups.
jack sink
Reviewed in the United States on July 26, 2024
After a month’s search with no luck at Lowes, Home Depot and Ace Hardware a long and challenging search on Amazon these fit Southwire 10amp, 250 volt fuse socket. Hallelujah!
Claude
Reviewed in the United States on October 30, 2024
Works.
Whomper
Reviewed in the United States on October 22, 2024
d
Sean Callahan
Reviewed in the United States on January 28, 2024
They work well!
jeff101
Reviewed in the United States on April 21, 2024
Got these to replace a fuse in a RadioShack multimeter. It's the exact same specs and size and works perfectly.
Mark
Reviewed in Canada on February 19, 2023
Works in my multi tester purchased on Amazon, thanks
khaled alamri
Reviewed in Saudi Arabia on June 15, 2022
جيد يؤدي الغرض لكن السعر عالي
Gun Guru
Reviewed in Canada on September 11, 2021
It's a fuse, fit properly and let the right amount of current flow in my multimeter. Why ask for more.
Learner 123
Reviewed in Canada on May 16, 2021
Product works
Bob Hardie
Reviewed in Canada on September 25, 2020
I use these fuses in my multimeter. The fuse protects the meter when it is being used to measure current in the 200 milliamps range.So how does one rate a fuse without destroying it? I don't know. As long as they carry the load up to their rated amperage, and blow when they are supposed to, I guess they will be fine. I didn't test one to see if it would carry 500 mA and blow over that just so I could evaluate it. I just have to have faith that the next time I overload the meter in the milliamps mode the fuse will blow.
Recommended Products
