Your cart is empty.
Your cart is empty.NTC 100K Thermistor Sensor, 3x15, XH2.54 2Pin, Wiring 1.3m(51.18inch), Compatible with Spider Hotend (Pack of 2 Pcs)
Darren
Reviewed in the United States on June 8, 2024
Lets be honest, it's not easy to wire in anything from the board to the hotend. That is to be expected. I found that this fit perfectly in my new all metal hotend. The original glass did not have any way to lock in place and I didn't feel it was safe. In addition I wanted the ability to go a little hotter with materials and this fixed both those issues. I swapped the thermistor. Hardest part was getting the glue off the connector for the original that the manufacturer put in place to keep it from coming loose. After swapping I ran an auto PID. From that point on it's been normal printing. The temps seem to stabilize quickly and hold solid. Great product for the price.
Tad B
Reviewed in the United States on November 27, 2024
NTC 100K Thermistor Sensor, Used this to fix Ender 3 V3 KE hotend that blobbed filament and pulled out the thermistor wires. The metal sensor is a bit longer than OEM. Fits the space and locks down with the set screw. Reuse the small oem connector by cutting wires at two different lengths, razor blade to cut the fireproof wrap, twist the ends and lay flat along the wires, shrink tubing to lock it. I could not get solder to stick, your luck may vary.
Robert Cochran
Reviewed in the United States on May 9, 2023
Nice little Thermistor for 3d Printing. I use with Ender 5 plus. I have mine setup with quick change plugs by the print head and these work with that setup for me.
Jester_84-07
Reviewed in the United States on March 22, 2023
Went back and forth trying to decide between two upgrades, the spider standalone hot end and aftermarket direct drive kit, or the micro-Swiss all in one direct drive extruder kit for like $30 less overall. Decided to go with the micro-Swiss in the end since overall it seems to get better reviews from experienced makers & seems to have more standardized parts availability. Needed a high temp thermistor, these ones were recommended for the spider, but match dimensions for the micro-Swiss so took a chance on em. We'll see if creality/amazon's recommendation turns out good. Will update this review if I have more to say after using, either good or bad.
Dave H
Reviewed in the United States on October 7, 2023
Super easy to pop in as replacement after I accidentally severed the wire on the old thermister. Glad This pack has two so I have a backup for the next time I'm a bonehead.This works exactly as advertised and has been stable and worked great.
Gregory
Reviewed in the United States on January 20, 2023
These work great in my Creality Spider high-flow hotend, I would say to snap them out when you find them though, i took a few weeks to find these in ads and in-stock
Recommended Products
