Your cart is empty.
Your cart is empty.Please note we are selling only the seat cover itself !Not the complete seat Installation note: please cover the foam with a piece of plastic/garbage bag before installing new seat cover, this will allow the cover to slide into position and make installation much easier. The picture above shows a seat with our cover installed on it, Made here in north America. replace your stock seat cover and fasten just like the original cover. Our covers are made of special cold resistant outdoor 4-way stretch Marine vinyl material (please note that this is not the vinyl that most of the others sell on the market, this is the very best vinyl available with a cold crack rating of -65) We take great pride to ensure that these replacement seat covers are made from the highest quality vinyls available.
Tom
Reviewed in the United States on September 8, 2024
Easy install. Size was good and it stretched as much as I needed it to. Took me a half hour to install. Photo was taken right after. The small creases you see in photo were gone after a day or two.
paul mccarty
Reviewed in the United States on September 2, 2024
Fit "like a glove"
Ken
Reviewed in the United States on November 9, 2023
Prepare to pull and stretch a lot to make this fit. It is poorly made, uneven sizing. One side was shorter than the other. When I first put it over the seat, it appeared too small, short on one side. I spent around three hours pulling, stretching and stapling and restapling it to make it fit. It did look okay in the end, but I would not buy it again.
J D
Reviewed in the United States on November 1, 2023
The only issue I had with this was the creases or seams rather I previously got one that was flat material and was simpler to align but seems durable.
Tricia
Reviewed in the United States on March 21, 2022
Great replacement fit and finish.
Recommended Products
$25.49
$ 11 .99 $11.99