Your cart is empty.
Your cart is empty.Designed for demanding anglers seeking ultimate versatility, this low profile quick release composite bracket allows users to quickly attach or remove a bow mounted MotorGuide Xi Series trolling motor for storage, maintenance or security. MotorGuide is dedicated to engineering and manufacturing innovative trolling motors and accessories for over 50 years. Proudly setting the standard for the most durable and easy to use motors on the market, we own the most accurate PinPoint™ GPS system, that provides anglers with superior boat control.
DonnE
Reviewed in the United States on February 22, 2023
Everything looked good until I installed the bottom bracket bolts through the deck of my pontoon boat. They were too short to accommodate the plastic washer and the flat washer as per instructions. These are stainless steel hex-head bolts that are most likely pricey and difficult to find in longer versions, especially in my small town.I ended up using some larger diameter flat washers, which allowed the nut to be fully tightened, and smothering the works with 100% silicon window caulking. Not best practices, but I will inspect frequently.
Terry Morris
Reviewed in the United States on June 27, 2022
Needed a way to take my trolling motor off so my cover would fit, this works perfectly. It was easy to install also. Just make sure you measure and fit before you start drilling holes. Mine is a tight fit, it has a very positive set with no wobble.
Antonio
Reviewed in Italy on January 16, 2022
Prodotto conforme alla descrizione. Arrivato con una settimana in anticipo.
Jay A. Baalman
Reviewed in the United States on September 24, 2021
Drilled 4 holes in trammel net deck to install. All hardware was included. Minimal impact on space at bow of jon boat. Excellent product. Very pleased
Sapper04
Reviewed in the United States on July 10, 2021
This is amazing for quick removal. It does leave the small puck on the floor, but you dont have a trolling motor in your way either.
NICK S.
Reviewed in the United States on June 29, 2021
I installed my trolling motor with this because I leave my boat in the water but don't want an expensive trolling motor to be stolen. Just pull the pin and take it with me. I was able to use this for my Minn Kota motor by just drilling a few holes.
B. Petersen
Reviewed in the United States on March 14, 2021
This fit my Terrova Riptide perfectly. Well made, just be careful tightening the bolt opposite the tab for locking, it will pull the bolt head right through.
RB
Reviewed in the United States on April 5, 2021
I have two one for my 55lb thrust trolling motor and one for my Deckhand DH 40 which I use to pick up that 30 lb anchor, works great in the garage.
travis
Reviewed in Canada on June 4, 2020
Surprisingly sturdy and well-made have not had a chance to install it yet
Chester Cheetah
Reviewed in the United States on July 15, 2016
Worked well. The plate only mounted on the motor one way which positioned the block close to the edge of the bow. I would have preferred to have this block further back. Works fine and is very easy to attach and remove the motor. If I were still fishing tournaments I think I would opt for the metal version to add more assurance in rough water but recreationally I expect this to work fine. I may still add a ram to secure the end of the motor to prevent bouncing in rough water or when transporting. The mounting clip was one solid metal piece, sounds like this may have been in partially plastic in the last.
Recommended Products
