Your cart is empty.
Your cart is empty.Service Entrance Insulator Wire Holder - 3/8" x 5" Bolt - Single-point wire holders are strong and compact. Single-point wire holders are strong and compact. Made with Porcelain and Galvanized Steel. Solid Rivet Through Head. Bolt and Nut type Wire Holder.
David
Reviewed in the United States on January 29, 2022
Strong
Janice Davis
Reviewed in the United States on August 10, 2020
I have not used the product yet but they appear to be well made and I believe they will support the 100' runs of three wire 2-0 cable.
Mike D
Reviewed in the United States on May 4, 2020
Stronger than it looks.
James Dunlap
Reviewed in the United States on November 14, 2020
Good product
Mike Maher
Reviewed in the United States on October 25, 2020
I used this insulator to anchor an overhead drop across my driveway with four #10 copper photovoltaic panel output wires, and one #6 ground wire, all supported by a braided aluminum cable tied to the insulator. The distance spanned was 46 feet. This has been through two hurricanes without incident, so I think the insulator has served admirably, although I understand some reviewers' concerns that it doesn't look sturdy enough. Winds from one hurricane snapped a water oak that was about 26 inches in diameter, and the tree was only 50 feet from the wires supported by the insulator.
Will
Reviewed in the United States on May 25, 2018
This clevis pin porcelain insulator can probably be used for cable service or phone line but not for electric supply line. My supply line is 200A and it did not look like it would support it for more than a few months. Even for 100A line it appears to be too weak.
B D
Reviewed in the United States on September 30, 2016
got it put up , and hooked up the electric fence wire to it, need to run a wire up and over some pens, and so I needed to put an insulator in the roof, to anchor the wire, the bolt is about 8" long so was easy to attach drill my hole (put sealant on the base) and put in the hole and go under and run the nut up tight, (used a fender washer under the nut).worked well for my needs,
Michael P. Poletti
Reviewed in the United States on August 10, 2015
Very HD unit should work well
Recommended Products
