Your cart is empty.
Your cart is empty.This Still has a beautiful 3" Diameter Reflux Column with four 2" site glasses, Dephlagmator on top of the Column and a Shotgun Condenser. The column can be ran in Pot Still Mode to make Whiskey and Moonshine or it can be ran in reflux mode to make high proof Vodka or E-85 ethanol. The boiler has a 2" Tri Clamp port, with Tri Clamp and Cover Plate. The port can be used to install an electric element with controller (please see our other items to see the controller for this still). You can also fire this still with a Propane Burner if you like. The boiler stands 28" tall and has a base diameter of 13 3/4". The bottom of the boiler is flat and recessed. This still also comes with: 1" drain valve with down spout. Carrying handles. 1.5" filler neck with tri clamp cap. 3" column connection. Top quality construction with beautifully rounded curves. Built from heavy gauge 304 food grade stainless steel. Polished to a mirror finish inside and out. Thermowell and Commercial grade thermometer with a 3" face. Copper packing is included for the column. This still comes with a book, "Moonshine" by Matthew B Rowley. Chapter's include: "Equipment; Ingredients; The Process; Fundamentals of Distilling; Operating a Pot Still; Whiskeys: Grain-Based Recipes; Rums and Washes: Sugar Based Recipes; Now That You've Made It: Moonshine-Based Recipes." Copper packing removes the nasty tasting sulfides from the alcohol vapor. This still gives you the best of both worlds. It gives you the strength and durability of stainless and the taste improving qualities of the copper packing. Everything you need to make alcohol is included except some tubing that you can buy at your local hardware store.
Debra
Reviewed in the United States on March 28, 2022
Works
Jesus Tirado
Reviewed in the United States on February 18, 2022
Missing Silicone gaskets !!
4teen
Reviewed in the United States on January 19, 2022
Highly recommend this company
Bill
Reviewed in the United States on December 31, 2019
A few years ago, I drove to southern Missouri to purchase a 13 gallon still with a three-inch diameter, two-foot column. I also purchased the 5,500 watt element controller.The visit was memorable. The fellow who owns this company was out front with a couple of employees working on some distillation equipment. I was amazed. An open faced shed sat on a gravel lot with an 800 gallon stainless boiler. I watched as these guys worked on equipment and they obviously are masters of their craft.I was a little taken aback by the fact these folks obviously supply major equipment (800 gallon boilers and complex equipment) to what has to be fairly major outfits, but he was willing to take the time to meet with me and give me a quick run-down of the equipment.Many of the things he sells, if not all of the things he sells, he designs and builds. The quality is superb. Examining the welds on my equipment, it is excellent welding work. I have been using this device for a few years now and have yet to replace the silicone rings or the heat-resistant tubing or valves that control the cooling kit.This 5500 watt element is the only way to go for a beginner. The element sits inside the pot so there is no open flame. This is the only way I would run distillation equipment inside. Using a 2 foot column, I can get 170 proof out of the spout - that is the average proof of the end product. The heads (the stuff coming out early on) hits 190. You do not want 190 proof dripping out near an open propane flame burner because this stuff will burn near invisibly. The only way you know you have a fire is stuff starts melting. But with the internal heating element, there's little risk of such. Even for an ADD hobby distiller like me.The two-foot column can be replaced with a four-foot column (which he will sell you or ship to you later if you are desirous of a higher proof alcohol) to up the proof to maximum (about 194.5 proof - which is as high an alcohol proof as you can get without using a vacuum device in a laboratory setting).If you want to run out whiskeys for aging then you can remove the column and use this still as a pot still.The column gets packed with either clay rings (raschig rings) or copper distiller's mesh. I use a combination of both - first half of the column rings and the second half mesh.The still controller is built with high-quality parts. I've taken it apart to examine it - it is put together well. The housing is very thick and of high quality. The cord is thick and durable and quite capable of handling the current.I have had no problem with this equipment beyond the normal expendable stuff. A friend was using it to distill water and ran the water level below the element causing damage, but that was easily fixed with a new element and a new amperage meter in the controller. - Lesson: Don't let your friends use your distillation equipment without strict supervision because they may run it dry and damage it and it strains the relationship.Check out this company's website - they offer a range of equipment that will fit any need - whether you are a hobby distiller or a master distiller for a distillery.Also, they answer the phone. I've called them a few times to ask a question or to figure out what equipment I need - they are responsive and pack the stuff they mail professionally so it doesn't get damaged.I have had a blast with this still and will no doubt hand it down to my children.I am a real person and this is a real review - hit me up at MoonshineGuy@protonmail.com if you have any questions about my experiences with this company and their equipment.
ET_Engineering
Reviewed in the United States on October 22, 2018
This still came with everything as described by Affordable distillery, polished in-and-out. I place my order on Monday, and received it next Monday, and I am station in Puerto Rico! Also, came with no damaged at all. It is a beauty, I am one happy customer.
Recommended Products
