Your cart is empty.
Your cart is empty.Ronald S.
Reviewed in the United States on August 31, 2024
Great replacement for original fuel float that works with the original fuel guage on 88 Ski Centurion.
TMW
Reviewed in the United States on May 6, 2024
I bought 2 of these to replace the original equipment in my 1996 Ranger 462VS Bass Boat fuel tanks. They were not exact replacements but are close enough and the best I could find. The packages had excellent instructions printed on the back and you do need to read them through before starting. I did have to trim the float arm length. I followed the chart on the package and they seem to read perfectly. One difference was that my originals had the ground wire attached by a threaded screw and these have a spade type connection. Rather than trying to thread a hole in this thin plate I just used the spade connector provided and used my own female connectors. I recommend coating that completed connection with a generous amount of good quality automotive silicone gasket maker to insure that it will not vibrate loose. This is the only step I took that was not spelled out in the supplied directions.
SouthernMD
Reviewed in the United States on March 2, 2024
This product works great, especially at this price point. The included directions make the install a breeze. The only thing that didn’t work is the included bolts were the wrong thread pattern for my tank but that was a nonissue as I reused my existing bolts from the old unit. This one is way more accurate and now I can be on the water without fearing I’m going to run out of gas!
thomas schueller
Reviewed in the United States on December 13, 2024
I finally broke down and fixed both tanks on my 89 Ranger 364v. Fixed it in less than an hour.
Roland
Reviewed in the United States on October 10, 2024
After installing the sending unit on my 30 gallon gas tank in my boat it actually works beautiful just make sure you keep the old one and duplicate the old one to the new one however it is installed inside the tank make sure you test it before you install it to the tank to make sure the gauge works properly on the instrument panel as well as the sending unit good product
Austin Fettes
Reviewed in the United States on April 4, 2024
I was nervous about ordering a new gas sending unit/float for my boat, but this worked perfect. Install was simple and it matched all the previous holes. Trimming it to the right length was easy as well. Only thing that I couldn't use were the provided screws being they were different thread pitch, but the old ones worked fine. For the price, I would definitely buy again if I needed to!
sh2007
Reviewed in the United States on April 27, 2024
I did not have to modify or anything it went right in. Works good so far.
Sheephead Slayer
Reviewed in the United States on August 29, 2023
Packaged well, with hardware and instructions included. I had to re-use the screws that held my old sender in, because they were coarse thread as opposed to the fine thread screws given. I checked the new sender by "bench testing" it with the gauge from my boat and a 12V power supply, and it accurately displayed sender arm position from empty to full. This install WILL require you to do some careful measurement, and then cutting the float arm and repositioning the float to a spot where it will slightly touch the inside of the bottom and top of the tank while extended to its full range of swing, so, take your time and measure everything ACCURATELY, and you will have good results. They say not to bend the metal arm, but I found that a slight upward dog leg in it right at the float, about 15 or 20 degrees only, would make the full range of operation happen better than leaving it straight.
Recommended Products
$40.99
$ 20 .99 $20.99
$62.99
$ 27 .99 $27.99
$69.70
$ 27 .99 $27.99