Your cart is empty.
Your cart is empty. Fitment:
Fits for Minn Kota motors with 3-5/8" diameter lower units from 2005 to Present, serial number prefix “WWAF” through “WWAI” or “J” through “V”.
Fit for Minn Kota Endura 46, 50, 55 / Endura C2 50, 55; Endura Max 50, 55 / Endura Pro 46, 55 / All Terrain 46, 47, 50, 55, 65, 70 / Camo 55XL / Edge 50, 55, 70 / Engine Mount 55 / Maxxum 55, 65, 70 / Maxxum Transom 50, 55, 70 / Pontoon Hand Control 55, 70 / Pontoon PowerDrive V2 54, 68
Also for PowerDrive 50, 55, 65, 70 / PowerDrive V2 50, 55, 65, 70 / Riptide 50, 55, 65, 70 / Riptide Edge 55, 70 / Riptide Maxxum 55, 70 / Riptide PowerDrive 55, 70 / Riptide Terrova 55 / Terrova 55 / Traxxis 46, 50, 55, 70 / Vector 46, 55,70 / Vector 3X 46, 55, 70 etc.
Installation:
- Disconnect the motor from the battery.
- Hold the propeller and loosen prop nut with pliers or wrench.
- Remove prop nut and washer. If drive pin is sheared, hold the shaft steady with a screwdriver blade pressed into the slot on end of shaft.
- Align new propeller with the drive pin.
- Install prop washer and prop nut.
- Tighten prop nut 1/4 turn past snug.(25-35 inch pounds)
- Be careful, over tightening prop nut can damage prop.
