Your cart is empty.
Your cart is empty.Minka-Aire L001021500S Receiver for F1000/F844/F556L, Grey
S. Foster
Reviewed in the United States on February 14, 2025
Thank you!!! for saving my dead Minka-Aire F1000, Dyno, Ceiling Fan.This receiver worked like a champ. I was afraid i was going to need to replace the entire fan, but then realized it can't be the fan motor because the light doesn't work either. I removed the steel cup that hides the ceiling mount and found the receiver; ordered this, and replaced it (the wires even have the same color code). Just be sure to power off (at wall switch or breaker) any other fans you have with remote controls so when you pair your remote to this receiver it doesn't affect them; then just return power to the fan with the new receiver and hold the center remote button for about ten seconds (it will flash a few times), and then you're back in business.
Thomas Cooper
Reviewed in the United States on August 26, 2024
I contacted Minka Aire when my fan died and they said this was the correct replacement receiver.When I hooked it up it would not respond to my existing remote. The instruction manual says to press the Stop button on the remote within 60 seconds of applying power to the receiver. The receiver did not respond. I almost sent it back. I have two fans. I guessed the second fan might be causing some sort of interference. I removed power from the second fan and was successful this time.This receiver did resolve my problem once I got past the pairing process with the remote.There are 2 things that prevent me from giving this 5 stars. First, there should have been some instructions included with the receiver specifying in detail how to pair it with the remote.Second, the line and neutral wires were too short to install it in my fixture. Both of these wires needed to be 2 inches longer than they were. The receiver that I replaced had slightly longer wires. Only 2 more inches were needed. Very inconvenient that they were too short.
DadZilla
Reviewed in the United States on June 18, 2024
Simple to install and works well. This wires right into where the light switch wire attaches to the fan so no batteries need to be changed. Make sure to check the model on your fan or light to make sure this is compatible. You will also need the compatible Minka air light switch for this to work.
Sam
Reviewed in the United States on March 19, 2024
It wasn't the exact size of the original receiver. The hold down bracket wouldn't fit, but it had stickey pads to hold it in place. The original receiver had failed. It was easy to replace and now the fan works perfectly.
Mark Twain
Reviewed in the United States on December 18, 2024
Easy to replace the defective receiver.
Mikey Mike and the Funky Bunch
Reviewed in the United States on November 26, 2024
Worked for my FN1000 Minke Aire ceiling fan when it would no longer respond to remote commands. Checked the wiring and still had power to the box leads so deduced that it was this unit and it was. Fan now working as if it was new. Really wish manufacturers would be more straightforward about replacement parts, but was able to find this through the minka website and find a part that was close enough to the repair manual on Amazon
Arturo Zavala
Reviewed in Mexico on October 21, 2024
Ordené un receptor Minka Aire, y me mandaron este producto que no es el de la foto y no me funciona para mi ventilador!!!
Brian P. Lawler
Reviewed in the United States on January 14, 2023
With this receiver and one of two remotes, you can control your Minka fan without the extra wire in the wall..My room has only two wires (plus ground) from the switch to the fan. By installing this in the fan, and then getting one of two remotes from Minka, you can control both the fan and the light. Otherwise it would not be able to control both.It's relatively easy to install (you have to disassemble the entire fan to get to the top), but it takes only a few minutes to get it in there.And, I chose the wall switch remote, which wires to the power only, and then transmits signals to the fan to control both the fan and the light. It works perfectly.
Jane V
Reviewed in the United States on December 17, 2022
Seller said it would work with my fan model but it didn't.
Recommended Products
