Your cart is empty.
Your cart is empty.Ideal for T-Track clamping or creating custom jigs, these rubber-tipped hold downs help prevent damage to workpieces and hold the workpiece in place. Offered in two different sizes for larger or smaller clamping requirements.
Joe
Reviewed in the United States on March 3, 2025
perfectly good hold down clamps
Customer
Reviewed in the United States on February 14, 2025
These work great for my drill press, which has a custom table with t-slots. They're small and take up a lot or real estate. Just a quick update... After using these for a while there is one thing that is a small annoyance. That little half-round spacer between the hand-nut and the hold-down gets sideways all the time, and it's kind of a pain in the butt to make sure it's aligned correctly before tightening the nut down. I guess I don't understand why they couldn't have been provided with a simple washer which would eliminate the problem. I'm deducting one star. If the folks who designed these things actually used them this would not be an issue.
Techmike
Reviewed in the United States on January 25, 2025
Using these clamps to hold a drill press vice in place, they work great, well made.
Richard S
Reviewed in the United States on December 15, 2024
These are fine quality and work as you'd expect. They are small by design and will only reach to hold about 1.5" thick workpiece. I bought an inexpensive mitre gauge direct from China and the slots in the fence are only 6.8mm. The 1/4-20 T-bolts of these clamps fit in that slot (M6 will also fit), and the T-tabs slide in the track and won't rotate when you tighten them. These small clamps are about the right size to use in the vertical face of the 3" tall fence in this mitre gauge.
Recommended Products
$29.33
$ 12 .99 $12.99