Your cart is empty.
Your cart is empty.Product Description
Cam Bearing Removal and Installation Instructions
-
Preparation Before Installation
Please clean the engine block up before installation.
Measure the diameter of the five cam housing holes and the arbor of the tool you received with a micrometer caliper. If the diameter of the arbor is smaller than the minimum cam housing hole, you can proceed to the next step normally. In the opposite case, you need to stop and send us an email.
-
Cam Bearing Removal Steps
Unscrew the arbor, insert the drive spool through the cam housing hole, and screw both together. Insert the arbor into the cam bearing and secure the spool stabilizer in other cam housing hole.
Tap the drive cap with a hammer until the bearing comes out. Remove the other four bearings in the same way.
-
Cam Bearing Installation Steps
Clean the new bearings and wipe them dry. 5 bearings are not exactly the same, note the mounting position of each bearing.
Unscrew the arbor, insert the drive spool through the cam housing hole, and screw both together. Lubricate the new bearing. Place the new bearing on the arbor and secure the spool stabilizer in other cam housing hole.
Mark Maher
Reviewed in the United States on March 4, 2025
This tool is built like a tank, I haven't fully used it yet.. but soon! I was quite pleased with the value for the money. It is machined solid, and threads plus hardware is of quality. This makes the job a breeze and your LS will be crushing pavement in no time if you use this while building!
Karen J.
Reviewed in the United States on March 10, 2025
gets those hard to reach bearings
Jacob Petitfils
Reviewed in the United States on February 21, 2025
Worked for me but had to file the diameter down to remove/install center cam bearing. Could just be my engine 05 Sierra 5.3l
plemans
Reviewed in the United States on February 13, 2025
Disclaimer, I haven't used this yet. I bought it because this summer I'm planning on rebuilding my trucks LS motor. this seems pretty solid when I took it out and put it together. it seems like it should all the bearings to go in nicely and the nylon centering cone fits perfect. I'm pumped as I've never installed cam bearings and just paid someone to do it for me. this sounds fun to do.
Jamjam92
Reviewed in the United States on November 2, 2024
This is a good quality tool. It makes removing cams easier.
K. D. Scott
Reviewed in the United States on October 7, 2024
High quality with proper tolerance's make for a fit against the bearings on install. This cam bearing tool works well for removal and installation. The weight of this tool helps with the impact of the hammer when driving the cam bearings in. A couple tips with the LS, use quality Sleeve Retainer gel and install the front three bearings from the front and the last two from the rear.
Marie š
Reviewed in the United States on October 4, 2024
I am beyond impressed with the Cam Bearing Installation Tool for Chevy LS engines! This 33" tool made the installation process for my LS1 cam bearings smooth and hassle-free. The quality of the materials is top-notch, and it feels incredibly sturdy in hand.The length of the tool provides excellent leverage, making it easy to align and install the bearings precisely. I appreciated the thoughtful design that allowed me to work in tight spaces without any issues. It saved me so much time and frustration compared to trying to use makeshift tools or techniques.If you're a DIY mechanic or a professional working on LS engines, this tool is an absolute must-have in your toolkit. It performed flawlessly, and I couldn't be happier with the results. Highly recommend it to anyone looking to tackle cam bearing installations with confidence!
Angie L.
Reviewed in the United States on October 20, 2024
I would have rather seen a softer material for the alignment cone. Iām afraid with it being steel too, one could end up damaging the first journal.
Recommended Products