Your cart is empty.
Your cart is empty. Product Specification
Pan head machine screws are machine screws with heads that are flat on top and rounded on the sides. Pan head machine screw length is measured from under the head to the end of the screw. Phillips drive is x-shaped for installation with a phillips screw driver.
Thread Diameter: 4mm
Screw Length: 14mm
Pitch: 0.7mm
Finish: Black Finish
Material: High Quality 18-8 (304) Stainless Steel
Package Included
50 x Pan Head Machine Screws M4 x 14mm
Warranty
MewuDecor hardware has the highest quality on the market. Buy with confidence. Money back or exchange guarranteed.
Ariel&Tyla
Reviewed in the United States on July 30, 2024
Got these for a class project. They hold nicely and the black finish is nice. M4 head is solid. Get these if you n need them. Can't go wrong.
P.B. Salamon
Reviewed in the United States on June 3, 2024
I do a lot of work on bicycles, which often use 6mm bolts. Stainless Steel fasteners work well on bikes because bikes get wet. These 60mm long bolts are long enough for just about any bike application, such as passing through a fork crown to attach a fender. If it's too long, just cut it off.I would prefer that these were not black because the black coating will chip or rub off over time. However, that's not a big deal.
customer
Reviewed in the United States on June 1, 2024
This bag of M5 x 0.8 x 25mm long machine screws is high quality. The thread major diameter measures about 4.93mm, very close to the nominal diameter. A #2 Phillips screwdriver fits perfectly into the screw head. The black coating is consistent and uniform. Very pleased with these screws.
mpounders
Reviewed in the United States on May 3, 2024
I got the M6 x 20mm size screws. The quality is good. I've been unable to find these locally. The threads and the finish are good. 304 stainless steel by itself is more resistant to corrosion than regular steel. The black oxide finish should add a bit more corrosion resistance. I was able to thread on a M6 nut without issue. Make sure to use the correct size Phillips head so that you don't strip the screw. These screws are good for indoor use. For use outdoors, use marine grade fasteners instead.
TB
Reviewed in the United States on May 29, 2024
These screws have a deep high gloss black finish with a top notch Phillips cut. They have some magnetism but they are stainless steel. Threads are .8mm and cut to within 1.5mm of the head. You will need a 4.3mm drill bit if you plan on tapping these. Complete with small plastic case.Cheers
Dwight Bumgarner
Reviewed in the United States on May 27, 2024
These are the correct size and have a good thread and quality. They fit with the M3 nuts I need to use them with.
Inna Tysoe
Reviewed in the United States on May 21, 2024
These are great for joining serviceable 3D prints I like to make. Most of the casings and hinged joints are about 12mm thick so I can recess these pan heads from the back and use threaded inserts to secure these to. Works very well. Almost everyone has a Philips head driver which is why I went for the cross shaped Philips head. These fasteners look nice with a semi-gloss black finish that doesn’t wear or chip easily for light/medium duty work.
It worked
Reviewed in the United States on December 5, 2024
It worked
Recommended Products
