Your cart is empty.
Your cart is empty.
APPLICATION INSTRUCTION:
1. Substrate formulations and surface energies may vary for different materials; each application should be tested for compatibility in a small range before large area application.
2. Wear gloves when you use this product to avoid any skin injury and see doctor immediately if swallow this product by accident.
3. The bonding surface should be clean and dry. Contaminated surface should be cleaned with isopropyl alcohol or acetone solvent.
4. Shake the bottle gently before using.
5. Use gravity feed wipe, knurled roller or brush to apply a thin, uniform coating thickness onto bonding surfaces, which is approximately 0.002 inch (0.05 mm) or less.
6. Apply promoter only to areas that will be fully covered with tape and a drying time of 30 to 90 seconds is recommended.
SPECIAL NOTES:
Completely use up this liquid contents as soon as possible after opening or seal securely for next use. Apply a thin, uniform coating to the bonding surface, using the minimum amount that will fully coat the surface.
Suitable on low surface energy materials before tape application to increase the initial bonding; operation temperature is between 60oF - 90 oF; coverage: approximately 75 m2 (800 ft2 ) per gallon (Based on 0.002 inch wet coating thickness). Cyclohexane: 45-50%; M-Xylene: 10-15%; O-Xylene: 5-12%; Ethylbenzene: 3-5%; Epoxy: 0.1-1%.
E H
Reviewed in the United States on February 24, 2025
This stuff works wonders on enhancing the 3m products i used to mount up. Easy to use, works very well
Indetrucks
Reviewed in the United States on September 14, 2024
I have an older classic car and the spare tire warning sticker that goes on the underside of the trunk was just not sticking. It's about 12"x6" and continued to peel off. I used one of these adhesion promoter pads on the underside of the truck where I wanted to put the sticker, let it set for roughly 4 minutes then re-applied the sticker. Perfect, stayed in place and still secure.
Laylalady22
Reviewed in the United States on September 12, 2024
Pros: Package extremely wellGood amount product for your moneyI've only used a tiny bit on something but it hears quite well or helps to bond betterFunctions are supposed toConsNoneI've only used it just as a sample briefly my main purpose of using it won't be for a few days so I'll update more than but for right now I'm quite pleased with this I would recommend it I would buy it again
Rene Bertrand
Reviewed in Canada on August 30, 2024
I didn't know this existed. Works Amazon. I have cable holders in the Jeep and they all fell off from the heat. After using this, they stayed stuck.
David F.
Reviewed in the United States on June 27, 2024
This is a must have to ensure a permanent adhesion when installing stick on parts that you want to remain in place permanently.
Misbah Suleman
Reviewed in Canada on November 17, 2024
Used them for installing a lip spoiler and mirror caps. I’m not sure how they would hold without this, but the install seems to be very solid. The wipes are a little rough so would not recommend using it directly on paint, just apply some directly from the bottle and use a cloth to apply
EJ
Reviewed in the United States on November 10, 2024
Really good product just what I needed it adds an extra layer of strength to your projects. To adhesive
PK
Reviewed in Canada on October 14, 2024
Works well
luis alvarado
Reviewed in the United States on October 10, 2024
Its work great thank you
Maria
Reviewed in Canada on October 10, 2024
poorly screwed, leaked while in storage, I do not recommend this store, they do not check before sending, and I do not have time to waste time on returning it now
Richard Schoenberger
Reviewed in the United States on September 4, 2023
Pads were dry and unusable. I didn’t use it right away but they’re sealed so they shouldn’t have dried up. I would not purchase again.
BF
Reviewed in the United States on November 7, 2023
Opted to use this brand of adhesion promoter instead of the 3M 4298 pads or the Primer 94 pen to get the most bang for the buck.As expected, the pad that I opened up was dry but I just laid adhesion promoter from the bottle onto the surface I was working on with the provided brush attached to the inside of the cap and then used the dry pad to carefully spread it over the working surface for complete coverage.Suffice it to say that I have more adhesion promoter left in the bottle than I will most likely ever need (along with 9 more pads). If you are a hobbyist that utilizes adhesion promoter often, this is definitely the best way to go to save costs. And it works.
Mrs. J D Charles
Reviewed in Canada on October 2, 2023
The product in the bottle worked well with the brush. Wipes appear to be dry so not sure how well theyworked. Stuck on some heavy embellishments, they appear to be really good, but you don’t get long toadjust position.
Recommended Products
$125.00
$ 52 .99 $52.99
$49.99
$ 22 .99 $22.99
$66.33
$ 31 .99 $31.99