Your cart is empty.
Your cart is empty.Designed to replace fuel line fittings on Cummins ISB and ISX engines.
Johnny
Reviewed in the United States on June 3, 2024
Bought these to do a head gasket on a PACCAR PX9. Made life a lot easier
Customer
Reviewed in the United States on June 24, 2024
Some of these injector lines are very difficult to tighten properly. This tool has been the best answer so far.
dale m.
Reviewed in Canada on November 24, 2024
Used this to replace a 17mm sensor. Fits perfectly, and strong....
D
Reviewed in Canada on January 27, 2024
Too thick does not fit for German brands vehicle.Should buy snap on tools.
james moore II
Reviewed in the United States on April 17, 2024
Worked great on my DD 13 injector fuel pass through tubes.
TH
Reviewed in the United States on August 1, 2023
Worked great removing injector line nuts. I would recommend.
AlexDelG
Reviewed in Mexico on October 7, 2023
Funciona bien
C. Hawkins
Reviewed in the United States on January 20, 2023
These are good heavy duty sockets for injector lines and the like. Many injector and sensor sockets spread pretty easily, but these are really robust and work very well. The 17mm fits Isuzu/Duramax fuel injector lines, as well as some exhaust sensors/lines for various OEMs. The 21mm is perfect for Paccar MX-13 fuel lines.
Just Josh
Reviewed in the United States on September 21, 2022
I got these sockets hoping that the 19mm one would have enough room in the center for me to insert a 1/4" drive 9mm socket so I could hold the center shaft of a shock absorber in place while I used the 19mm socket to torque down the top nut on the shock absorber. Unfortunately it didn't work out as the 19mm socket is too narrow inside to fit the 9mm socket. These look like they would work well for their intended purpose though so I can't fault them for not working with my "off-label" project.
squirrelchew
Reviewed in the United States on June 16, 2022
The 17mm socket here is absolutely required for doing some sensors, like the pre-turbo EGT on a CJAA from a 2011 VW Golf TDI.Solidly built, as one would expect from a Lisle tool.
dinodog
Reviewed in the United States on May 29, 2022
I used the 21mm on my front struts of my 1998 VW TDI. It worked great. Nice and hefty build.
Roger
Reviewed in Canada on October 14, 2022
All good
Dakota peck
Reviewed in Canada on July 14, 2019
They make life much easier. I’d prefer a thinner wall for tight engines but great tool
Recommended Products
$23.49
$ 11 .99 $11.99