Your cart is empty.
Your cart is empty.Cleans Threads in Soot Sensor Holes. Use with 7/8" hex socket or 3/8" square drive. Important: Use anti-seize.
AMAZON SHOPPER
Reviewed in the United States on September 30, 2024
the thread pitch is correct so I'm happy
Joseph M.
Reviewed in the United States on July 6, 2024
Works great
Enrique
Reviewed in the United States on June 18, 2024
Good
Anonymous
Reviewed in the United States on May 19, 2024
Just what I needed for thread repair
Harold Ramstad
Reviewed in Canada on November 3, 2024
Would like to send back. Came up as a tool for the socket I bought for my box sensor. Pleas send me a return decal.
Nolan
Reviewed in the United States on November 14, 2024
Great for replacing soot sensors, they are always a pain. If your lucky and get it out without pulling all the threads or just breaking the bung off then you need this tool.
Rajesh Chohan
Reviewed in the United Kingdom on November 11, 2024
Good
Uno
Reviewed in Australia on April 21, 2024
Liked the quality
Mustache Mike
Reviewed in the United States on September 20, 2023
I bought this to try to restore the threads when I took the particle matter sensor out of my Ford 6.7 diesel exhaust. It would’ve worked great if I hadn’t messed up my threads so bad it would work great for cleaning up threads but the stainless seem to be too hard to restore threads that were badly damaged, but I would buy it again for the next time
Nikki
Reviewed in the United States on July 27, 2023
This little beauty saved my husband from having to cut the old threads off and weld a new piece on my exhaust.. Was a pain in the butt for him to rethread the pipe but working it in a turn and backing it out with lots of lubricant is they key its just tedious if its a hard to reach spot.
Mark Price
Reviewed in Canada on October 3, 2023
When removing a stubborn vaporizer nozzle from a transit Dpf, it damaged most of the threads. With this tread chaser I was able to restore the threads and avoid a costly Dpf replacement. Tool arrived faster than a replacement filter would have. Must have tool when working with newer diesel engines.
Eric
Reviewed in Canada on August 11, 2022
I especially use this for cleaning up axle nut threads. On axles that measure 22 mm x 1.5 mm. I run this thread chaser through the axle nut just to make sure that there’s no defects. Now I am less likely for the axle not to pile up and cross thread on the axle shaft.
CTR
Reviewed in the United States on November 14, 2022
I bought this to chase AIR injection port threads in one of the steel tubular exhaust manifolds on a 1986 Chevy. They are also M22 x 1.5. The only issue I had is the pilot on the end of the tool prevents it from threading into the manifold all the way before bottoming out(not a problem if using it for it's intended use). I chose to face it off in my lathe. Also, as with all cutting tools use a good quality cutting oil. Ridgid Nu-Clear is my go-to. These will also work on Cummins oil pans that use a M22 x 1.5 drain plug.
Recommended Products
$28.37
$ 13 .99 $13.99