Your cart is empty.
Your cart is empty.Product Description
Safety Lid stay 105 degree with Soft close Hydraulics Support Hinge for Toy Box
The lid hinge have 2 Way installation
Top Opening & Upward Opening
Install this lid support via Top opening or Upward opening base on the door you want to install. Only refer to instruction in package, you will find to install lid hinge easily.
Lid will lower slowly and gently to avoid smashing fingers.
105 Max Open Angle, Compact Design Lid Support For Install in Tight Fit Areas
The lid hinges supports opening the lid at a maximum Angle of 105 degree.
The compact design allows for installation in tight fit areas.
Toy box
Safety is the priority. Kids are able to open toybox easily or with a little force. It fits kids without too much strength. The soft close design protects the kids from being hurt. Due to this lid stay hinge, kids will have great fun with their various toys
Cabinet
The hinge is indispensable for kitchen cabinets to preserve culinary cookware. After installing the hinge, cabinet doors will swing up or down for your convenience. It is strong and sturdy.
Storage Chamber
Whether you are students, or you have worked, you are ready to store lots of spare books, or store the tools or devices for your job. You can open the chamber independently with no need for others’ help
Jim S.
Reviewed in the United States on July 1, 2025
This worked initially when I installed it but failed only a few months later. Probably cycled less than 50 times
Customer
Reviewed in the United States on February 18, 2025
I don’t usually write reviews, but this is the fourth soft close support that I have purchased for an oak toy chest! This is the only one that actually works to support in open position and also soft closes all the way!! The others allows lid to drop in final position… The videos of these that aren’t working, if you look are not installed correctly!
Chip Wood
Reviewed in the United States on January 17, 2025
Correct placement of the mounting plate is the key to the installation. Notice the arrows on the mounting plate. The arrows will line up with the lines you draw using the measurements from the installation instructions. Because they sent me measurements in millimeters and not Imperial, I gave this review four stars instead of five. My installation was for a full overlay for a top opening lid. I measured 70mm from the rear wall and drew a parrallel line down the right wall. I then measered 45mm down from the top of the box (bottom of the lid) and drew a line on the wall parallel to the top. The lines need to be long enough to go beyond the mounting plate so you can line up the arrows on the mounting plate with the drawn lines (see the photo).Once you screw the mounting plate in, attach the support in the fully open position and you will be able to line up the top of the support with the lid. Mark it, drill your holes, and attach the lid mounting plate. Detach the lid support from the box mounting plate, twist the top of the support into the lid mounting plate, and re-attach the support arm to the box mounting plate.That's how I did it and it works perfectly.
Plumbob
Reviewed in the United States on April 16, 2025
Product as described with good directions for installation. I expect it will perform as others I have used (from different sellers) in the past.
Customer
Reviewed in the United States on June 19, 2024
We had an old cedar chest sitting around, and I finally cleaned it up and added these great safety hinges to the lid. They do a great job of keeping the lid up when needed and then slowly closing the lid in place. They were easy enough to install.
charity w.
Reviewed in the United States on December 28, 2024
The media could not be loaded.
Yves Laverdière
Reviewed in Canada on March 6, 2022
Très correct pour le prix, livraison rapide
Nigel Barry
Reviewed in Australia on March 28, 2021
The media could not be loaded.
Thomas W. Paterson
Reviewed in the United States on December 20, 2020
The media could not be loaded.
Recommended Products