Your cart is empty.
Your cart is empty.Product Description
Features:
Install in Seconds:
Swap from the old plug to this new one took all of maybe 10 minutes and the new plug hooked up and works like a charm.
Conversion:
This plug can connect generator with a 3 wire outlet to the 4 wire connector. There was ample room inside the plug housing to run the wires as needed. Fully assembled it feels solid and it works perfectly.
Good Conductivity:
Made from solid brass to reduce friction and overheating, working to conduct electricity to machine.
Robert L. McKinniss
Reviewed in the United States on February 2, 2025
Good product and good price
Troy B.
Reviewed in the United States on February 16, 2025
Great product as described! Worked as intended! Great value
Brad Z.
Reviewed in the United States on January 20, 2025
Good product
RENODOC
Reviewed in Canada on September 28, 2024
Richard S.
Reviewed in the United States on June 4, 2024
Working fine and no issues installing.
Claude Michaud
Reviewed in Canada on June 28, 2024
Bon rapport qualité prix.
Linda
Reviewed in Canada on November 22, 2024
Decent quality for dry applications. No problems so far!
Will
Reviewed in the United States on November 16, 2024
I normally buy the Journeyman-Pro products but in the interest of saving some money I purchased this instead. No it's not quite the quality of the equivalent Journeyman-Pro but it is not bad. The contacts do not side in and out of the power inlet as nicely as the Journeyman-Pro but it does fit well. Another thing is the strain relief on this is not as robust as the Journeyman-Pro and is dependent on the two screws that hold the receptacle end into the outer shell. Whereas the Journeyman-Pro has two screws that actually clamp the cord in place at the back side of the assembly.. The method Saihisday uses to clamp the cord does provide a cleaner look to the assembly though.At approximately four dollars less cost than the Journeyman-Pro it warrants a five star rating.
Customer
Reviewed in the United States on November 1, 2024
Good fit. Easy to install.
Russell R.
Reviewed in the United States on October 8, 2024
Looks to be made well, works ok for now.
Karkey
Reviewed in Canada on October 11, 2024
It was perfect. Wired it up and it worked great
Pierre Fortin
Reviewed in Canada on September 8, 2023
Exactement ce que je recherchais
Rick
Reviewed in the United States on October 30, 2023
Cable used here is 12/4 with heavy 5/8" covering, too large for the plug body. The interior wires and their insulation is just fine. The wires join the connector in axial direction with screws at the side or radial directions (4). It is a well designed and built connector.The plug fastens well to the four stranded conductors. This is not Hubble. Strain relief comes in better designs but at a very heavy price. This is good enough, particularly if you use a smaller diameter cable. Be sure it is 12/4 for wires, stranded, not solid. Whether for power in-feed to a home, trailer, camper, or welder, use a disconnect on any of those to physically remove a power source before you use this.
Recommended Products