Your cart is empty.
Your cart is empty.* 4 Inch (100mm) Width - To Be Used On A 4 Inch Or Wider Vise * 14 Gauge (2.0 mm) Max Capacity For Steel, * 1/8 Inch (3mm) Aluminum * Removable Hardened Finger Dies: 1", 1" and 2" * VICE MOUNT; * Magnets mount for easy and convenient removable; * Vice NOT included
Derek R.
Reviewed in the United Kingdom on September 7, 2024
Very useful device, easy to use and well made the bigger the vise you have the more versatile the folder can be.
dudeinin
Reviewed in the United States on July 13, 2024
does well for what its intended for
edat
Reviewed in the United States on March 13, 2024
I had an idea that this tool exists, and I had a project with a lot of bends in .068 stainless. It was a lifesaver! Anybody who has tried to bend metal by clamping it in a vise and hammering it over — this is so much more precise and accurate!
Customer
Reviewed in the United Kingdom on March 12, 2024
Easy to order, prompt delivery. Very happy with the product. Magnets are strong and work well. Product works well.
Mr christopher hekimian
Reviewed in the United States on February 16, 2024
I’m using these products to bend 1/8” diameter steel rods. I think that this might be beyond what the priduct is designed for but it is doing the job- with a little bit of accommodation. I am happy with the product. I recommend using it with a rotatable vise that is mounted vertically on a vertical bar that can be clamped to your bench. Rhis has been working well for me.
Richard Cooper
Reviewed in the United Kingdom on December 8, 2024
Fabricated all sorts of brackets
Javier Valdes
Reviewed in the United States on December 22, 2024
These are great for small jobs that don’t require a full sized press.
Adam L.
Reviewed in the United States on April 30, 2024
So far this little brake has worked amazingly well. I got it for a project where I needed to bend some 14g stainless steel and it handled it just fine despite it being the max rated material it can handle. Finish could be a bit better, but it's cast so I'm not complaining. Definitely worth the money for small fabrication jobs. Works way better than those folding brakes you get at harbor freight. Keep in mind since it's vice mounted it takes quite a bit of strength to bend thicker material. There's not a lot of leverage on a vice arm. But it is doable.
Jon n
Reviewed in the United Kingdom on April 10, 2024
For model making, small metal works, this works very well!Have used this vice brake to bend spring steel, with very accurate results. Be very precise and you can achieve perfection.Also heat and quench if bending spring steel.
Alain Rivard
Reviewed in the United States on September 7, 2023
the steel finger is to soft it is bending and compressing under load, nice tool ,but cheap material.
A J Turrall
Reviewed in the United Kingdom on August 12, 2023
Not bad, magnets are a bit weedy but other than that good..
IMNoOne
Reviewed in the United States on May 23, 2022
This is a GREAT tool....in the right place. Bought this to do "Jog" or "Joggle" bends. The TOOL is wonderful, and it satisfied 1/2 of my needs. It can do 1/2 of my job, but I can't do the "reverse" "out" bend. HOWEVER..this IS A GREAT adapter for 1-plane bends.
Michael H Jank
Reviewed in the United States on May 22, 2021
Ease of use. Tough...bent 1/8" x 2" mild steel...with a cheater bar. Impressed!
Recommended Products
$514.00
$ 99 .00 $99.00