Your cart is empty.
Your cart is empty. About Pinch Weld Jack Adapter Frame Rail Protector Standard Size for Most Vehicles and Floor Jack
Product Details:
The Jack Pad is designed for pinch welded sub-frame vehicle and as such will likely fit for a variety of vehicles and floor jack stands.
It is made of solid billet aluminum by CNC and anodized orange surface that is solid enough to work long.
Unlike the plain rubber jack pad, it extra comes with 2 installed Neodymium rare earth magnets mainly for holding them in place while you position your jack and increasing holding strength while lifting vehicle.
The maximum load of this floor jack pad is 2 Ton.
Pad Measurement:
Channel width: 0.51"
Channel depth: 1.02"
Overall height: 1.34"
Overall length (the base diameter): 2.83"
How it works:
It is easy to use this tool
①locate the correct jacking point,
②place the magnetic mount flat against the pinch weld,
③place your jack underneath and jack away.
It can fit perfectly, the magnetic portion holds them in place while you position the jack.
Package: A Jack Pad X a soft nylon insert with 2 installed magnets.
Note:
Please allow 0.01-0.05 inch difference due to manual measurement.
Troy L
Reviewed in the United States on December 26, 2024
I use this to before placing my jack. It saves the frame of your vehicle from damage.
Sebastian
Reviewed in the United States on November 13, 2024
I purchased this thing to better protect the jack point tabs from getting bent while maintenance. For that purpose, it does exactly as advertised. What I wasn't expecting is just how strong this little thing would be.After doing an oil change, I forgot to remove this little guy from under my car. My family and I left the next morning for a road trip from Seattle to the Bonneville Salt Flats in Utah. We drove through every element - heat, freezing cold snow/ice, salt water, desert, high wind speed 90+ mph. This thing stayed in the exact same spot I left it for over 2000 miles. If it wasn't for the fact that I needed to rotate my tires after we got back home, it most likely would have been on for thousands more miles.In the pictures you'll see I found the puck after jacking up the other side. Surprisingly, it was only a little dirty with minimal to no scratches at all. Cleaned up real easy.4 stars because while it's great for use with a jack stand, it doesn't fit all vehicles. Fits on my Mazda CX-9 but not my Mazda 3.
Mark Scott
Reviewed in the United States on September 22, 2023
The product worked great, it fit right over the pinch weld. The magnet was so strong that it stayed on the car after I forgot to take it off and did a test drive!
M. COLLINS
Reviewed in the United States on August 21, 2023
Works well.
Customer
Reviewed in the United States on July 9, 2023
Would recommend to anyone great quality
christopher
Reviewed in the United States on October 23, 2023
It has strong magics and has been used over 100 times. Very sturdy and keeps the floor jack from bending the metal seam. Plus it has stayed on the car dozens of times of forgetting to take it off the car. I work 45 miles away and it has stayed on for days until I remembered. Best money spent on something like this
Stephen K. Sampson
Reviewed in the United States on October 27, 2022
This adapter is well made and fits the pinch weld on my 2015 Ford Escape.
Customer
Reviewed in the United States on February 10, 2021
These worked pretty well for my application which was lifting an ND Miata using a sliding jack. They are well made yet lightweight. They were just a tad bit shallow in my opinion but every car is different. Overall very happy with how they worked.
Recommended Products
$15.99
$ 6 .99 $6.99