Your cart is empty.
Your cart is empty.Product Description
Wrench tap 1/4-1/2"irwin. Made of shock-resistant and heat treated S2 steel for maximum strength and hardness, ideal for maintenance and repair work, manufactured in china.
From the Manufacturer
T-Handle Tap Wrench, for tap 1/4 to 1/2-inch, features a sliding handle with spring tension tap, and may be extended full length in either direction for more leverage, and has a positive grip knurled knot. Irwin tools are made of only the finest materials, manufactured to exacting tolerances.
Suzanne
Reviewed in the United States on March 12, 2025
Good tap handle for smaller taps. Lots of reviews saying they broke and didn't work properly, but it has worked great for the few holes I've had to tap out!
mark schmidt
Reviewed in the United States on February 7, 2025
Good design and quality!
Mark Vorhees
Reviewed in the United States on January 11, 2025
Would buy again
AZRay
Reviewed in the United States on September 8, 2024
I purchased an Irwin 1/4" NPT tap and this 1/4" to 1/2" tap T-handle thinking the handle would work fine for the 1/4" tap. However, the tap handle tool is too small for the Irwin 1/4" NPT tap. The end of the 1/4" tap to be inserted into the T-handle is square shaped and slightly more than a 1/2" across; won't fit. So be aware that a tap's end size for T-handle insertion can be much larger than the stated tap size. The T-Handle quality appears to be fine, but just too small for the tap I purchased.
Jacob dipaula
Reviewed in the United States on March 28, 2024
The T handle here was made well and would serve it purpose if i needed this. but because i ordered another product that went with this and turned out i messed up the thread size, which was my fault. I no longer needed this. Seemed well made and would serve it purpose.
Jon from Central CA
Reviewed in the United States on February 25, 2024
I have US and metric sets of tap & dies from that discount tool store (farbor hreight). I am only a hobbyist, use them rarely, but the tap wrench included doesn't hold the taps well. This one works great. I have also replaced some of the taps I use frequently with better quality. If you struggle with a bad handle, or don't have one at all, this is great. Note - there are different sizes of handles, so make sure you get the right size for your taps.
Michael L. Beasley
Reviewed in the United States on November 5, 2024
Bought the handle and a 1/4”-28 tap from them. Handle will not tighten down enough to hold 1/4” tap. (Same company)
D. W.
Reviewed in the United States on July 29, 2023
Purchased this to clean out the threads in the undercarriage of the car to mount a receiver. It's a specialty tool and I haven't used it since, but it worked phenomenally well for the task at hand and I know that if I need to use it again it will be solid and work like it should.I've never had an issue with IRWIN tools like this, which is why I went with this one. Solid, well constructed, worked exactly as needed!
B Healy
Reviewed in the United Kingdom on December 15, 2023
Great piece of kit. Should have bought one years ago.
jigga009
Reviewed in Canada on August 1, 2018
Works as advertised.
Aaron R.
Reviewed in Canada on October 22, 2018
Good
Zuberman
Reviewed in Canada on September 21, 2017
Unfortunately this handle did not fit the half inch tap that I wanted to use it on.
Recommended Products
