Your cart is empty.
Your cart is empty.The new Innovate Motorsports MTX Digital Series "Dual Function" Water Temperature and Battery Voltage is now available. This "Dual Function" gauge is the perfect way to monitor critical engine parameters on one display. The 2-1/16 inches (52 millimeter) gauge features a water resistant casing, interchangeable faceplates and bezels, locking connectors for simplified installation, and MTS serial connections used to connect with other Innovate devices for logging to your PC, iPhone, iPod Touch, iPad, LM-2, DL-32.
tashley2
Reviewed in the United States on November 22, 2024
I got the gauge in for the water temp and battery voltage i hooked it up per instructions and worked for all of about 2 mins shut the key off turned it back on and never came back on no matter what I did. Went back to aem gauge instead
HUGOBOSSRUFF
Reviewed in the United States on July 21, 2022
This thing is terrible can never switch between voltage and temp only stays on one or the other
Edbert Adams
Reviewed in the United States on September 19, 2021
Easy to install will update if any issues.
jgchemie
Reviewed in the United States on March 27, 2021
I installed this gauge and the water temperature works well. However, the voltage gauge has no reading. In the directions on page 4 under section 2.2 point 3 it says "coming out of the female two pin connector of the gauge you will find a black wire with a stripped end. Connect this black wire to the same ground source as the gauge". There is no additional black wire with a stripped end coming out of the pin connector. I've contacted customer support but no response. Will update the rating if this issue ever gets resolved.
jon
Reviewed in the United States on April 9, 2021
I didn't get the log work software
Reviewed in the United States on December 30, 2020
Very ell built gauge. Lots of functions and easy to read display. Very pleased with it, especially compared to cheaper gauges. Wiring is solid with good connections etc.
Stephen
Reviewed in the United States on October 25, 2019
This guage is FANTASTIC. LOVE the dual functionality. For a small car, fitting more than one function in the same gauge is SWEET.The installation was pretty easy and all my wires were the perfect length and had a little room to spare. I bought the Mishimoto coolant hose adapter and ran the sensor from my upper radiator hose (where the hot coolant come out of the engine) and wired through the firewall to a set of pillar pods from Fap9tuning.Love the setup, definitely plan to get the oil pressure/temp gauge soon.
Amy Laffin
Reviewed in Canada on April 18, 2016
Jose Badillo
Reviewed in the United States on December 26, 2015
Simple and convenient way to monitor your water temp and your voltage! Easy to install, but you do have to weld a bung, to the place of your choice, or use adapters with 1/8 NPT threads. Easy to set up your perimeters with the included Logworks! If you plan on monitoring it, update it, or change your perimeters through your laptop, leave your "OUT" cable accessible!
Recommended Products
