Your cart is empty.
Your cart is empty.This is the ball stud that threads into the side of the engine block and supports the one end of the Clutch Z-bar. These are often worn out or go missing when rebuilding the engine. If you are converting your car to a manual trans this part is also a must to support the end of the z-bar. This is a hardened steel part - with a ball end so that Clutch Z-bar can move on the end. slao comes with the grease seal so the grease stays in the end of the shaft of the z-bar and does not end up all over your engine and fresh restoration. Replacement for: All Cars 1964-72 , , , , Elcamino 1970-72 , 1969-72 1967-69 , , 66-74 1970-78 / Trans / 1973-77 A-body , , , all Full Size Cars from 66-74 just about Any Car
Good seller thanks for your help
Reviewed in the United States on February 19, 2025
Fast shipping good price good quality thanks
Steve Reed
Reviewed in the United States on May 21, 2024
Great product fit perfect
Greg Anderson
Reviewed in the United States on October 13, 2023
Good quality. got it in a timely manner.
Stewart Shuman
Reviewed in the United States on June 22, 2022
Works great
gary giarraputo
Reviewed in the United States on February 11, 2022
Perfect
W.Smith
Reviewed in the United States on December 17, 2022
Very good quality and at a good price, I would recommend.
Michael Simon
Reviewed in the United States on September 6, 2019
No issues this tightened up the linkage and fit perfect on sbc 350 1964 c10 3 on tree
Recommended Products
