Your cart is empty.
Your cart is empty.4.5 out of 5 stars
Macattack
Reviewed in the United States on June 29, 2024
Great quality brass wheel hexes. On the Axial SCX10 PRO these do not leave very many threads to tighten down the wheel nuts so thread lock is your friend.
Win231
Reviewed in Italy on June 28, 2024
Trattasi di secondo acquisto, quindi già testati! Sono ottimi, di buona fattura ed esteticamente curati. Dimensioni perfette, utilizzati con ponti Axial SCX10-2 non originali ed originali. Nessun problema.
azua
Reviewed in the United States on May 7, 2024
These for perfectly, resolved my problem of the portal weights rubbing inside the wheel. I do recommend.
Scott M.
Reviewed in the United States on February 7, 2024
Use on SCX10III Jeep JLU, nice quality product for great price.
JimmyC
Reviewed in Canada on February 15, 2024
Fitted perfectly to my Axial SCX10 III early Bronco. Would buy again.
3D Drucker
Reviewed in Germany on November 21, 2024
Spitzen Qualität von Injora. Sehr gut verarbeitet und passen perfekt.
Thu
Reviewed in the United States on November 17, 2024
These fit perfectly on my builds and I always go back to getting these to add the weight I need for all of my 1/10th scale trucks!
Alexander
Reviewed in Canada on January 18, 2024
Beat place for a bit of weight.
Bree
Reviewed in the United States on August 17, 2023
For scx10 iii get these! Do not get the treal ones they do not work. These fit absolutely perfect!
Customer
Reviewed in the United States on June 29, 2023
I experienced severe wheel wobbles until installing these Injora hexes. The Axial ones are too thin and didn’t work well with other wheel sets. 1/3 the price of competitors too. Amazing value.
Uwe
Reviewed in Germany on November 2, 2023
Passt leider nicht, montiert man die Spacer sind die Achswellengewinde zu kurz
Customer
Reviewed in the United States on October 22, 2023
Just like any wheel hex that has the set screw pin, these won’t fit an SSD axle. These did fit my KYX axle though. I tried shaving off some width right behind the set screw hole to get the pin to line up in the axle stub hole, but if I go any farther I will ruin the hex by cutting into the threads. Overall a nice weighted and wide wheel hex but just doesn’t fit my application completely.
Michael setty
Reviewed in the United States on October 16, 2023
Used on scx10 III builders kit . No issues or complaints
Recommended Products
