Your cart is empty.
Your cart is empty.Product Description
This page features iJDMTOY Red Lens LED Bumper Reflector Lights Compatible With Honda CR-Z CR-V Insight, Compatible With Acura TSX Wagon. For detail fitment information and product specification, please refer to product feature bullet point(s).
RRoman
Reviewed in the United States on July 2, 2025
Stopped working leds are flickering not bright anymore
Rony M.
Reviewed in the United States on December 18, 2024
Esta muy bonito luz muy clara
RayP
Reviewed in the United States on September 30, 2023
I purchased the product and installed it very easily. There was a problem and the product failed. I contacted Amazon and the seller was also contacted. The seller sent me a replacement immediately. A very honest seller and everything turned out great.
Kirk
Reviewed in the United States on June 7, 2023
Definitely what I was looking for! Works great, looks great, and is as expected. Keep in mind when buying these that you will have to use the metal retaining clips from you original reflectors. If you do not have those you will need to use the screws from them then As expected since working in body shops all my life aftermarket vehicle parts don’t t provide the hardware for the part. That’s why you always save your hardware. Excellent product!
HPPardo
Reviewed in the United States on March 17, 2023
As others have said, the way these fit into the bumper does not allow it to clip in and instead you'll use a screw to fit it in place. I used some little ones I had lying around, not sure the exact size but I'd say they're 1/4" length at most and that worked great.As for the wiring, instructions say red(light) to red(car), white(light) to green(car), and black(light) to black(car). These wires being the brake +, running +, and negative lines respectively. This was incorrect for my car, not sure if it's due to year or just a mistake on the part of the user who created the initial guide on Crzforum, but the correct wiring is red(light) to green(car) and white(light) to red(car).The easiest way to tell for sure is to test it ahead of time, unplug the light connector and use a multimeter to test what gets power from where. I used some T-shaped quick connects to do this which let me reconnect them easily but some may not have that chance so be mindful!I don't know of their longevity as I've only just installed them but they lose a star for the instructions and lack of screws.
Nate
Reviewed in Canada on November 13, 2022
Nice setup, but wires are a bit short. ended up just using it for the reflector function to replace the one that fell out.
jesse
Reviewed in the United States on September 18, 2018
The media could not be loaded.
Rminor1
Reviewed in the United States on February 12, 2013
Was easy to install on my 2010 Honda Insight. Just take out the bottom clips that hold the bumper on and it gives you enough room to use a flat screwdriver to pop out the OEM reflectors. Drill a hole in the bumper for the wires and just snap in the new LED light. Took off the tail light. Then used a string with a weight to drop down to bottom. Then tied the wires to the string and pulled the wires up. I slid on some wire protection covering incase it rubs the frame anywhere. Then tapped into the clip for the LED tail/stop light wiring harness. Tape it up and put the tail light back in. Works great. Would have been nice to have the wire tap connectors or a connector that would be a "go between" the connector for easy hook up. Then a instruction manual to help with the install also would have helped.December 2019 updateLed light are still working great. I had one wire come loose last year. I reattached it and I put hot glue all over the connector to seal it from outside contaminants. I love that people behind me know when I hit the breaks with 5 light blast them. Never have been hit from behind yet. Hurry.
Recommended Products