Your cart is empty.
Your cart is empty.1x new Ignition Resistor with 2 screws. Fit for Ford/New Holland Tractor 2N, 8N(Before Serial Number 263844), 9N.
Jordan M
Reviewed in the United States on February 14, 2025
When I tried mounting this the holes didn't line up like others have said. It looked right so I put it back to back with the original just to check. The holes lined up exactly, so I tried again. I put both screws through the holes simultaneously and wiggled them around I was able to get them set and screwed in. Was awkward and took some effort and patience but I got them in with no drilling.Resistor works great and my 8N starts right up now. Only downside was that the included screws were the wrong size, but luckily my old ones were still in good enough shape to be reused.
ET
Reviewed in the United States on September 30, 2024
Replaced and worked
Customer
Reviewed in the United States on September 15, 2024
This resistor is identical to the original that was on the 1948 Ford 8n tractor. After installing it and replacing my ground battery cable, my tractor purrs like a kitten and when the tractor is running the battery recharges perfectly.
Clarence
Reviewed in the United States on July 5, 2024
Fit my 9n tractor with a little hole drilling. Works perfect
sparky
Reviewed in Canada on July 19, 2024
Works great just like the one it replaced
Chad E Chambers
Reviewed in the United States on June 26, 2024
I replaced my entire electrical system on my tractor from the complete wiring harness, to voltage regulator, key switch, start button, and this resistor block. This fit perfectly and works great.
Steve
Reviewed in the United States on December 16, 2024
Worked perfectly for my 48 8n. Fit in place of the old one. Just make sure the screw heads don’t make contact where you mount it, put a piece of electrical tape behind it to prevent a short.
Customer
Reviewed in the United States on October 18, 2024
This thing was almost impossible to install. The mounting screws were the wrong pitch, mounting holes were not spaced correctly, the poles were bigger diameter than OEM (too big for the wire terminals that attached to the old one). But the worst part was that the resistor element did not even work. It is supposed to decrease the voltage from 6 to around 3 volts. This one only dropped the volts to 5.5. YOU WILL FRY YOUR COIL IF YOU USE THIS. Promptly returned.
Me
Reviewed in the United States on October 10, 2024
Product was just what I needed and arrived quickly.
Recommended Products
