Your cart is empty.
Your cart is empty. Specification
Material: plastic
Length:15cm (5.9inch)
Weight:0.8g
Outside diameter:3mm
inner diameter:1.5mm
Package Included
10pcs Antenna Tube
10pcs Caps
Note:antennas are not included
Erin Mather
Reviewed in the United States on September 15, 2021
I bought these to replace the ones on my quad that broke. These broke too. Time for a new antenna strategy.
Heltzmj1129
Reviewed in the United States on January 30, 2021
It's hard finding these. Works perfect for my mount.
catman
Reviewed in the United States on February 27, 2020
It does exactly what the name says. I holds my drone antennas. Holds up to all the abuse I can dish out........except for prop strikes. That was the antenna mount's fault, not the antenna tube. Once I moved them, I haven't broken one since.
Customer
Reviewed in the United States on December 8, 2020
These are more brittle than I would have liked. They snap pretty easy in a crash. But they have worked perfect for what I needed them for! Will buy again!
Chasj2025
Reviewed in the United States on December 17, 2019
Works as intended, nice and is a good way to protect the very fragile tips on the antennas
Josh
Reviewed in the United States on December 11, 2019
Not much to say about them. Price was ok. I used one and cut it in half and the resulting two pieces were the perfect length for my XSR antennas. Have not crashed yet so durability is an unknown. No complaints though.
Sidat Young
Reviewed in the United States on April 30, 2019
If you build These are a Must to help protect your antennas Works very well what's the right now make fit and make the choir look a lot
Brian
Reviewed in the United States on April 10, 2019
I could see just super glueing these to a multicopter frame as a cheap way to keep your antennas in check, but I use them as replacements for this product:https://www.amazon.com/gp/product/B01CI22YD8(These tubes have a slightly larger diameter than what comes in the above kit, which makes for a tighter fit.)They are great at keeping the antenna wires away from the props, and they hold up very well in normal flying conditions. They are stiff enough to keep from flexing into the prop. They can be bent slightly, if you are careful. Of course, the same rigidity that keeps them stiff and away from the props also makes them a bit brittle, so expect them to break relatively easily in a bad crash.They are relatively cheap, so just make sure your expectations are realistic, and you'll be happy.
Recommended Products
