Your cart is empty.
Your cart is empty.Compatible with: Husqvarna backpack blower - 150BT 2007-2021. Please note: If your model and serial number are not listed here, this part will NOT fit. Please check your owner's manual for correct replacement part identification and application.
jonathon
Reviewed in the United States on March 2, 2024
Great product, arrived in time and easy to install.
Mike M.
Reviewed in the United States on November 16, 2024
Easy replacement. Works great. Sturdy. Comes with everything you might need to replace the old part.
Angie Hoff
Reviewed in the United States on November 14, 2024
Not a match for the 150bt, close but wrong. Has no bolt to hold the carb attachment. Keep shopping skip this model. Now I have to drive to the UPS store to return it. Save yourself the hassle.
Marvin Walton
Reviewed in the United States on October 13, 2024
Perfect Just what i needed
Jose Ramirez
Reviewed in the United States on June 6, 2023
Have had this handle for over a year now and I can say it has not let me down. Fit my old leaf blower like a glove. Needed a little bit of tweaking here and there with the tension but once you get the trigger tension down, you're good!! Plastic on it seems rather sturdy so we'll see if it lasts as I very frequently use my leaf blower.
Bob Montgomery
Reviewed in the United States on June 14, 2023
Should have replaced this long ago. Everything fit perfectly for my Husqvarna 150BT. I had never replaced one of those before today and only took me maybe 20 minutes. I think the trick was to remove the fuel tank. Three screws on the bottom and it will pop out for easy access to the electrical connections and the clip holding the cable.Much better price than I expected too.
Bigbluedude
Reviewed in the United States on May 12, 2023
I could not find a control handle for my BT125 so I tried this one I think it is no longer manufactured. The new throttle cable fits and works perfectly. The start stop electrical connections needs to be modified as it has 2 male connectors and the existing motor wire has a male and female. The handles diameter hole which is used to attach to the nozzle is too large and needs to be packed with rubber to reduce the I.D. By about 1 inch. All in all it takes about 30 minutes to install and I am happy as my original control handle was no longer functioning.
Karl Kox
Reviewed in the United States on May 29, 2022
My wife drove over the handle of my leaf blower. Of course it's my fault for keeping it within 5 feet of where she usually parks.Either way, this got me going again on a 150bt. Good as new and easy to install.
Recommended Products
