Your cart is empty.
Your cart is empty.Husky Mud Guards are a perfect match for your fender; more than a match for anything the road kicks up. Delivering nail-tough protection for your truck, van, or SUV thanks to its thermoplastic construction. Engineered for the ultimate in impact resistance, plus, the added invincibility of Husky Shield for an extra layer of defense for your vehicle’s paint. Available in single or dually factory-tire width. Proudly made in the USA, guaranteed for life—like all Husky products.
BV
Reviewed in the United States on May 27, 2025
Bought both front and rear flaps. They fit ok. Rear requires one hole to be drilled because the manufacturer failed to line up with the factory hole. My big concern is that unlike the OEM models these are not smooth on the front facing side. I fear that this will cause snow and slush to build up and provide unnecessary extra strain on the attachment points. Otherwise they look fine.
Customer
Reviewed in the United States on March 10, 2025
fit great and are bigger than factory guards, you do have to drill one hole in back ones to line up with factory hole in fender well. Very satisfied.
book hound
Reviewed in the United States on January 8, 2025
Amazon indicated mud guards would fit 2023 Ridgeline. Box said 21/22 Ridgeline. Bottom hole in guard did NOT match hole in 2023 Ridgeline. Had to remove rear wheels to drill new holes. Not a big deal but took considerable more time to install. Fit fine after adjustments.
JeffO
Reviewed in the United States on June 10, 2024
These fit and look every bit as good as the HONDA OEM's.I didn't install them as I had a 15k service due on my Ridgeline including the tire rotation, so I figured it would be a quick and ez install at the garage up on the lift while the tires were being rotated. Wasn't quite that ez but with a little finagling, the mechanic got them to line up and fit right.f you are looking for these for your Ridgeline, you'll be satisfied for sure.
richard
Reviewed in the United States on December 18, 2023
They will fit the 2023 Ridgeline HPD package with the addition of drilling one hole in the mudflap for the bottom screw. Thats the only reason I gave it a 4 star instead of a 5.
Chuck Birtcil
Reviewed in the United States on September 29, 2022
When installing these, be sure to take a few minutes to thread the screws into each of the the vehicles manufacturers pre threaded holes at each location. Remove the screws then proceed with following the installation steps for each mud guard. This extra step makes it a whole lot easier to line up the threads and the screws as you install them. Also, be sure to start each screw by hand to avoid any cross threading issues. These are nicely manufactured guards and fit well on the vehicles and models they are specifically designed to fit.
Todd A. Anderson
Reviewed in the United States on September 18, 2022
You will need a short screwdriver plus and the offset screwdriver (right side of photo) for the rear flaps. On my 2023 Ridgeline RTL the factory installed hole on the flaps does not line up with the notch / hole in the truck fender liner, so just drill a new hole through the FLAP (not your nice truck fender liner). Use thread lock on all screws.
N. Koz
Reviewed in the United States on December 24, 2020
Is the price point arbitrary? I mean $42.00 for little pieces of plastic and let us not forget the lousy instructions. How about $19.99; I could stomach that.For example, their rear flap drilled bottom/inside hole does not match up to the spot where the slide clip is installed. Why? I mounted the top two screws and marked and drilled the flap to correspond to the rectangular inner fender opening that accommodates the slide clip and will then accept the screw.
Recommended Products
$86.19
$ 38 .99 $38.99