Your cart is empty.
Your cart is empty.Searching for a hard working, entry-level residential controller. X-Core is on the case. Hunter's popular XC controller is now X-Core. Plug in the revolutionary Solar Sync ET sensor and the X-Core is converted into a Smart controller, using advanced water conservation technology and regulating irrigation runtimes based on locally measured weather.
Mark K. Salamack
Reviewed in the United States on September 19, 2024
The instructions are pretty well written and easy to understand. This is easy to connect the wires from the manifolds and it is easy to program the device. It works as it is supposed to....I would recommend it
Mike Bone
Reviewed in the United States on September 13, 2024
I own 4 of these controllers at various properties I own. They are easy to program and they hold the programming in the event of a loss of power. I have a rain sensor on one controller that stops the irrigation from going on in the event of rain. It has saved me a LOT of money. THE BEST
JustBeYou
Reviewed in the United States on August 24, 2024
Live in AZ so these things don’t last too long. But will keep buying until they stop making them. Prob should invest in 5 of them now. I installed last one myself. (50 yr old female). Take photo on phone before disconnecting to match replacement. Worked like a charm. Western side of building. Wish they built a cover to cover the cover on my house. Will prob get around to building my own. To keep it shaded.
Charley B.
Reviewed in the United States on August 10, 2024
I am a retired Irrigation Specialist for the State of California. I was in charge of the Irrigation at San Diego State University for 24 years.We used these Hunter Controllers for small areas on the campus where using large expensive computerized controllers was not practical.The Hunter X Cores were the best. I just replaced mine at my home that I installed 11 years ago in 2013. We had a power outage and when the power came back on the Surge fried the clock because It was not on a surge protector.These clocks are EASY to install. Get the OUTDOOR model even if it is going in a garage because the transformer is built in and it is all wired with a plug ready to go. Plug and play! Great price on Amazon compared with Irrigation Supply houses. Home Depot or Lowes won't carry these . Don't waste your money on ORBIT or Rainbird dumbed down crap from HD or Lowes.
Bennett H.
Reviewed in the United States on October 22, 2024
Old timer went out, needed 8 series. Order it, received it next day, easy to install, timer and cycles are a breeze to set. Works great, cheaper than at local stores.
sallysue
Reviewed in the United States on August 4, 2023
I like the simplicity of it, very easy to set
Damián
Reviewed in Mexico on May 30, 2023
Programador Hunter clásico pero versión para exteriores, más fuerte y con puerta con llave.
Kiepe
Reviewed in Germany on April 2, 2023
Kann diesen Artikel in Deutschland nicht verwenden da nur 120VAC. Eine Beschreibung welche Art von Stromanschluss wäre von Vorteil gewesen. Eine Rücksendung kommt nicht in Frage, weil ich die Versandkosten von 49,99 Euro übertrieben finde. Schade das ist das erste Mal, das ich so einen Kauf negativ bewerten muss. Nicht aussreichende Artikelbeschreibung.
Ravinder Gupta
Reviewed in Canada on July 27, 2022
I bought Hunter Sprinkler XC800 XC800 X-Core 8-Station controller Timer last year, it is out of order and water runs in loop, at-least four cycles instead of one cycle. I hope supplier will contact me for replacement or repair?
Serjio Strem
Reviewed in Canada on June 2, 2021
Bought it as replacement for old controller. Easy to install. Easy to red instruction. Easy to operate. No silly phone or WiFi connection (which is good).
jmk63
Reviewed in the United States on July 28, 2020
Rain Bird worked ok for a long time. this unit was a drop in replacement for the RB, and wired up easier with the station locations right in front of my face - horizontally - not vertically like RB - and the keys access to the unit is nice versus another padlock. Looks cleaner. Had a Hunter rain sensor wired in to the RB as a ground interrupter to unpower zones if raining. Obviously this model is newer and the rain sensor wired directly in to the box. Programming was fairly straightforward. Read the manual many times - go do it - reread and do it again. I have programs A/B/C doing exactly like I want, when I want them. I have not extended the capability to connect Hunter's 'internet weather' optional features to the box. I have a rain sensor, and Programs B/C are set up to deal with cooler, potentially moister weather. Just switch from Program A to B when early fall hits, and B to C in mid/late fall. then wrap it up for the long dark Pacific Northwest wet winter....see you in spring with Program C, then B, then A. Simple.
Flying Fool
Reviewed in the United States on May 16, 2019
From all indications, this is a very well made controller. Installation was pretty much straight forward. No mounting template was included by Hunter so I created one by tracing the backside of the controller. The template greatly simplified pre-drilling the mounting holes and preinstalling the necessary anchors. I also temporarily removed the door to keep it from swinging shut during the installation. Setting the date and programming took a less than 5 minutes thanks to a very intuitive display and controls. I'm pleased.2021 Update: After two years of use and the controller is still functioning perfectly and, perhaps of more interest, I've learned several tricks about programming.First: It pays to revisit the Owner's Manual after a season or two of use. When I became frustrated about not being able to manually start a full cycle of all stations without having to first temporarily change one of the program's start time, I found a thing called a "test program." With the dial in the RUN position, press and hold the PRG button. The station number will be displayed and the time will be flashing for two seconds. Use the plus or minus or buttons to set the run time from 1 to 15 minutes. The run time needs to be entered only once and after a slight, 2 second pause, the test program will start.Someone asked about setting up a dwell time between watering each station and from my experience the answer is both yes and no. The controller has a built in feature that allows setting the dwell time between stations of 0 seconds up to 4 hours. If one needed a longer dwell time (highly unlikely) then, from a technical point of view, the dwell time could be set much longer.Because the timer has three (3) program settings and each of the three has three (3) separate, available start times it would allow you to set nine (9) individual start and run times for up to nine (9) separate stations. Even if you’re skilled at programming the timer, this could take some time to get set up correctly. The good news is that the program can then be safely stored in non-volatile memory for future use.See page 26 of the users manual for using the built in program for setting the dwell time between stations. One Dwell setting applies to all stations. Once the Dwell time, the Start time and the Station times are set, then each station runs in sequence and the dwell time is added to the over all program run time. I've attached a copy of my cheat sheet that's served me well these past couple of years. My Dwell is currently set to zero.Hope this help with your decision on what to buy and/or how to use.
Diddier
Reviewed in Mexico on October 5, 2017
Really a very good product, robust for outdoor, packaging came without a single scratch, a good recomendation of product !!
Recommended Products
$199.00
$ 82 .99 $82.99
$105.18
$ 48 .99 $48.99