Your cart is empty.
Your cart is empty.Product Description
Features:
- Durable and practical
- No rust and anti-static
- Fits diameter 1.98mm Roland cutting blade
- Excellent performance with high precision
- Ultra-hardness, super toughness, more wear and edge grinding wheel with ultrafine polishing, edge sharper.
- Come with a storage case
Package included:
1 x Blade Holder for Roland Cutting Plotter
Jorge C. Escalante
Reviewed in the United States on September 30, 2024
Worked perfectly
Marshall D. Walker
Reviewed in the United States on March 25, 2024
I use it for my 60 degree blade
J.Michael Ates
Reviewed in the United States on June 12, 2023
Base is a bit longer and skinnier. Works but not as well as a non generic.
Jean
Reviewed in the United States on December 7, 2023
The media could not be loaded.
Dan W.
Reviewed in the United States on November 6, 2023
Good fit for Roland CAMM-1 Servo GX-24 cutter; performs better than other budget blade holders and features a cap that adjusts depth easily similar to the original holder, diameter is 11.5mm and the depth between the bottom of the collar and the tip of the blade is about 27mm
john cusick
Reviewed in the United States on January 11, 2022
Definitely not new. Scratches all over. Cheap plastic
Shazim Mohammed
Reviewed in the United States on March 16, 2021
This blade holder is no good. It looks good at first but fits pretty slack inside my Roland GX-24 blade holder head. I can't send it back because I live overseas so I took some heat tape and wrapped it around the aluminum area to make it fit a little more snugger which it helped a bit. I wouldn't buy this blade holder again.
Tommy Versetti
Reviewed in the United States on January 18, 2019
Fits the Roland GS-24... Only issue it that the head of the holder (the part that faces down with the blade exposed) is about 1/1.5mm longer than the stock Roland holder. May cause an issue when cutting thicker material because there isn't any space between the blade & material as it moves around cutting. I saw a couple tracks throughout the material where you could tell it wasn't cutting but the blade was touching the material enough to leave a mark... **BTW I exposed the blade to be half the thickness of a credit card.. maybe I try to tuck it in more to stop the scratching... Main thing is that it didn't effect the weeding process. None of the scratch lines were deep enough cuts to come up during weeding so I'm cool with it. Just a heads up. I would order again if I needed to.
Recommended Products
$379.99
$ 99 .00 $99.00
$16.99
$ 6 .99 $6.99