Your cart is empty.
Your cart is empty.HPS 3" (76mm), 3" Long High Temp 4-ply Reinforced Black Silicone Offset Coupler Hose meet and exceed SAEJ20 industry standards, ideal for heavy duty pressure connections and provides excellent resistance for high temperature applications. HPS performance silicone Offset Coupler Hose is designed and engineerd to meet high performance requirements specified in various industry standards, therefore make it great for marine and industrial use, custom turbo or intercooler piping fabrication, DIY intake or radiator cooling system. Technical Specification: Product Type: Silicone Offset Coupler Hose. Temperature Range:- 65 deg. F to + 350 deg. F (177 deg. C). Reinforced Layer: 4-ply. Hose Inside Diameter: 3" (76mm). Hose Outside Diameter: 3.39" (86mm). Hose Length: 3". Offset from the centers: 1/2". Wall Thickness: 4.5mm (+/- 0.5mm). Color: Black. UV and ozone resistant. Remark: Silicone hose is NOT compatible with fuel or oil.
Lee S.
Reviewed in the United States on January 30, 2024
Slight offset was needed for my application (Subaru rigid turbo inlet). This coupler fit exactly as needed and was shipped very fast.
DNH
Reviewed in the United States on May 25, 2023
This saved my butt. Aftermarket turbo ended up aligned just a tad below my alternator, this allowed me to run my intake/maf tube raising it above the alternator. Just what the doctor ordered.
Marcos Amezcua
Reviewed in the United States on January 17, 2023
This will not properly clear the TGV's unlet you grind them down SUBSTANTIALLY. The original APS coupler was a bit thinner and WAY more offset to clear the TGV's. Even by trying to force it on, there was not enough clearance to the TGV or the hard breather lines for this to work properly.I cannot fault this product for not fitting. It is a high quality silicone coupler and works as intended. It just didn't fit for my application.
mopar426
Reviewed in the United States on March 12, 2022
this off-set coupler helped me get an air-intake duct around a custom header tank without having to 'kink' the duct,so, it did the job, I were very happy to find this piece to make the job a little bit easier,
Jeff H.
Reviewed in the United States on July 4, 2021
Do not expect to get more than one hose clamp that is not a t-bolt even a worm gear barely fits. The offset is less than a1/2”.
William Ekey
Reviewed in the United States on February 26, 2019
Perfect
julio a lopez figueroa
Reviewed in the United States on March 10, 2015
Great quality construction, it just won't fit my set up. It doesn't have the proper offset to connect it betweeny turbo and turbo inlet, maybe I can finally finesse it in but I doubt it. If you looking for a replacement to the 3" aps offset coupler this is not it.
Recommended Products
