Your cart is empty.
Your cart is empty.Holley 216-43 Side Hung Float
uncle-buck
Reviewed in the United States on October 12, 2022
I use these in an older Holley 4160 marine carburetor.Set the primary bowl float so that it is level when the bowl is held upside down or use a 7/64" gap between the toe of the float and the roof of the bowl.Set the secondary float so that there is a 13/64" gap between the heel of the float and the roof of the bowl.Use the appropriate diameter drill bits as gauges for the settings.
Ranae
Reviewed in the United States on October 27, 2010
I ordered this hoping that it would come with the very special spring that holds the float properly inside the carb. It did not come with this spring and I had to order it separately.
Recommended Products
