Your cart is empty.
Your cart is empty.Product Description
CONVERTS 110V AC to 12V DC and works with LED compatible dimmer switches from Lutron, Leviton and more; Please use the shortcut "ctrl+F" in the User Guide file included in the Technical Specification of Product information to find the matching dimmer. SMOOTH AND RELIABLE DIMMING from 0 to 100% with no flicker. BARE WIRE CONNECTIONS AND KNOCKOUTS for easy installation to electrical code; See diagram in images for wiring instructions. CHOOSE AN APPROPRIATE LIGHT LEVEL for any room, any mood, or any time of day. HITLIGHTS QUALITY, ETL-LISTED & MADE IN THE USA and backed by a FIVE year from HitLights for peace of mind; Contact our US-based customer service team at any time for no-hassle troubleshooting and replacement or for any questions about purchasing or installation.
Manufacturer Contact Information
Made by HITlights: For questions about the product or product usage, please call (855) 768-4135 to contact the manufacturer.
Neil Mayer
Reviewed in the United States on February 8, 2025
Works great for dimmable ribbon lights
SeaRanchDog
Reviewed in the United States on January 8, 2025
Very easy install, even for a non-electrician. Works quite nicely.
Fred S
Reviewed in the United States on January 13, 2025
Great driver to use when installing a lot of LED strip lights.
Blaine Williams
Reviewed in the United States on May 31, 2024
The media could not be loaded.
Eric
Reviewed in the United States on October 28, 2024
Bought this to replace 2 50W drivers that were undersized by a cabinet contractor that didn’t know electrical. The old drivers flickered and were running hot. This was easy to install. Ran it with lights full for 24 hours and temp stayed under 104f. No flickering at any dimming point.
A.R
Reviewed in the United States on October 14, 2024
I used both led driver and strip from hitlights and it specifically said to use the magnetic dimmer from Leviton which I have and at 70-100% the led lights shut off and the driver makes a loud humming noise.If anyone knows what happened and a fix lmk! Thanks.
Count Orloff
Reviewed in the United States on March 31, 2022
I'm reviewing the 40W model meant for LEDs. Absolutely had to have a dimmable model that didn't buzz or overheat when using with two pin reflector MR16. Using a Lutron 120V wall dimming switch. There are three 8 watt bulbs in this array. I am using Hyperikon 12 volt bulbs. Had an old magnetic transformer which worked all right but it did buzz especially at mid and low dim settings. Also I needed a transformer small enough to fit into the ceiling puck which is exposed on this light. For some reason many LED transformers are six to eight inches long which is ridiculous. Honestly it has taken me years to find a good solution for this particular installation. When the house is absolutely dead silent I can hear a very low hum from the lights. I'm pretty sensitive but I don't find it bothersome. The last transformer I had was far more noisy and I've heard others that are unbearably loud. This one is fine plus the fact that it dims very dim, probably dimmer than any other LED I've ever seen which typically only go down to about 40%. I would say these dim down to maybe 5%. I will only take off one star because the transformer is still too large. I had to hacksaw it down to fit into this 4-inch diameter puck. The metal enclosure seems to be intended to be surface wired and it actually has a conduit input hole. I wish they had a more compact bare model without the enclosure, that was meant to be wired inside an electrical box.
Jaxon Spencer
Reviewed in the United States on May 8, 2018
The media could not be loaded.
Recommended Products
