Your cart is empty.
Your cart is empty.Replace missing, damaged or worn-out Class ZZ gages from existing sets and libraries. ~ Each pin is individually marked with the size. ~ Fully hardened to 60-62 RC. ~ Finish to 10 Micron or better. ~ Overall length is 2". ~ Tolerance is - .0002".
KD
Reviewed in the United States on April 11, 2023
I ordered a 0.387+ go pin gauge. It comes in as exactly shown from picture, no cert, used, sticky, no brand. I can not even put it in use. Garbage.
maniac121
Reviewed in the United States on December 13, 2022
Measures spot on, very useful for indicating a rifle bore prior to chambering or threading the muzzle. It can be done without, but a gage pin is far easier than chasing lands and grooves.
Cat
Reviewed in the United States on April 19, 2021
Very accurate
Sparkyv
Reviewed in the United States on January 19, 2020
Performs as designed. I use it as a verification standard for my calipers; the 0.356" dia. is in the range of most projectiles I use so it fits my application nominally.
Boyd Taylor
Reviewed in the United States on April 3, 2019
Wax paper with the anit-rust coating was fused to the pins, I had to a bench grinder with a brass wire brush wheel to clean them up. I would have saved time by running over to my local shop supply store.
Kevin
Reviewed in the United States on April 27, 2016
Exactly as described
Recommended Products
