Your cart is empty.
Your cart is empty.Hardened And Ground for Single End Mills Only.
Davila
Reviewed in Mexico on February 8, 2025
Cumple con los requisitos
L Holman
Reviewed in the United States on February 26, 2024
Good price and good quality.
Jut
Reviewed in the United States on March 26, 2023
Nice fit and fast shipping
Vince B
Reviewed in the United States on February 26, 2023
Tool feels and looks just like the 70 dollar version from bigger name tool houses. Spins true and works as advertised. Was a little nervous with it being 30 bucks. Very satisfied with the chance I have taken on this. I use it to spin a 1.5in indexable tool for facing.
Chris
Reviewed in the United States on July 15, 2021
Great value for the price. Holds tight tolerances on both roughing and finishing processes.
N. Prescott
Reviewed in the United Kingdom on May 12, 2021
Really solid end mill holder. Replaces one of the alternate types that proved way to weak and flexible in use.
James I. McLallen
Reviewed in the United States on April 8, 2021
These work well although one of the holders seems to be too small. It seems to be off by a few thousandths of an inch. I should be able to lap it with valve grinding paste to make it work.
GLB
Reviewed in the United States on August 30, 2020
the end mill shank slide in perfectly-- almost creating an air-tight piston... Two set screws matched my end mill flats' position too. Fit in the R8 spindle fine too.
mike44
Reviewed in the United States on December 16, 2020
received the endmill holder and have not yet installed it. Looks like a quality tool.
Dave in Calgary
Reviewed in Canada on October 17, 2020
this piece does not accept 1/4 inch end mill bits. The hole size is much closer to 6 mm. While the tool can still be used, it is disappointing that it is not the correct size as promoted.
Louis
Reviewed in Canada on December 9, 2018
Good set, I use them un my milling machine.Fit is good and no runout as far as I can tell.I can leave the tools in them unlike r8 collets, this makes a quicker work!
Customer
Reviewed in Canada on January 26, 2018
It works well, but I had to use a tap to remove burrs
Customer
Reviewed in the United States on June 5, 2016
good for hobby machining
Recommended Products
$92.40
$ 43 .99 $43.99
$28.50
$ 14 .99 $14.99