Your cart is empty.
Your cart is empty.58 Piece Clamping Kit for a 3/4" T-Slot ~ Stud size is 5/8"-11 ~ Made of powered casting steel for stronger strength. ~ All parts are heat treated. ~ Includes 4 each of 3", 4". 5" and 6" studs, 4 coupling nuts, 6 flanged nuts, 6 forged steel step clamps, 6 t-nuts, 12 steel step blocks and 1 wall rack.
Kyle
Reviewed in the United States on May 30, 2024
Like the other reviewers mentioned, the completely PLASTIC holder for the set has mounting holes that look like they were made with a chisel and a hammer. The clamps and bits etc seem to be fine, t nuts fits fit and holes are drilled centered. Go with another brand...
Bruce Wilson
Reviewed in the United States on May 28, 2024
👍👍
Jason
Reviewed in the United States on May 22, 2024
Works 👍
Customer
Reviewed in the United States on December 30, 2024
the wrench is pretty cheap but the t-slot cleaner is a nice freebie with the this set
Shawn
Reviewed in the United States on December 30, 2024
For the hobby machinist they are good. I did have to clean up the edges and retap a few t nuts. Overall good for the price.
Thomas A. Bell
Reviewed in the United States on December 28, 2024
High quality clamp set for the money. Happy with this purchase.
Sergio
Reviewed in Mexico on May 22, 2023
Todo bien, completo y funcional, obtienes lo que pagas muy satisfecho.
Manny
Reviewed in the United States on November 17, 2023
I’ve read other comments, I figured id throw my 2¢ in. The studs are purposefully made not to extend through the T-nut to save your table and to prevent mushrooming the stud to where you can’t take the T-nut off, I purchased the 5/8” for my mill and all hold downs are heavy duty, all studs are threaded, all teeth are sharp and square. Maybe they have different places making these? For very short lock downs I just cut a short piece of all thread. But my set was worth it, no problems.
JU
Reviewed in the United States on August 2, 2019
Contrary to the typical Chinese clamp kits this one is very well packaged and doesn't arrive a jumbled mess. I ordered this for a G0704 mill. The 1/2" portion of the slot fits perfectly but you'll need to take .018 off of each side of the T to fit the G0704 table. I put all six in the mill vise on their side and removed the material with a 3 inch face mill. The organizer is blue and well made.I highly recommend this kit.
Dan
Reviewed in Canada on March 30, 2019
Parfait pour ma fraiseuse ce n'est pas la plus grande qualité mais fait bien le travail
benoit
Reviewed in Canada on October 29, 2019
Malheureusement j'ai du le retourner , trop gros pour mon utilisation
jimmy turgeon
Reviewed in Canada on December 28, 2018
But received with broken plastic holder.
Sean Rendell
Reviewed in Canada on September 12, 2017
Works well and seems to do the job. Good combinations of sizes too. Some of the nuts and rods are a bit scratchy feeling when threading them together with your fingers, but will likely free up after a few uses. I will buy them again if I ever need more.
Recommended Products
