Your cart is empty.
Your cart is empty.Product Description
10 gauge mild steel material; Knockout punch unit used on; 7/8 inch designated size; die; slug-buster used on model/Brand; 7306SB, 7310SB, 7646Pgsb, 38520, 7606SB, 7610SB used on item part No.; 1/2 inch Conduit/pipe size; Greenlee Brand
From the Manufacturer
Greenlee round standard replacement metal dies must be used with a matching punch and draw stud to operate. They can punch quick clean holes through metal up to 10 gauge (check specs for specific punches). They can be used with battery-powered, hydraulic, ratchet or manual drivers. Properly assembled through pilot holes, they will make clean, fast and accurate holes. After cutting the slug falls free in the die, and a quick tip drops it out.
Stephanie Dominguez
Reviewed in the United States on February 25, 2024
As described. Fast shipping and good quality product
guna
Reviewed in Saudi Arabia on October 19, 2024
The product was and excellent.
TERONUS
Reviewed in the United States on May 9, 2023
I use this with hydraulic pull through head on 0.063 In. Type 304 stainless steel. Cuts better than the old-style punches and far easier to clear slugs.
Richard L. Christy
Reviewed in the United States on February 10, 2023
If I can't tell the truth then don't ask me for a review
B K
Reviewed in the United States on July 3, 2021
the part that was sent to me seemed like it was a used part and not even the right part. not even close to the right part as advertised. even had to paya good amount for shipping.
Collin Edwards
Reviewed in the United States on July 22, 2014
Not what I wanted.
Recommended Products
