Your cart is empty.
Your cart is empty. Replacement Bottom Deflector with Vinyl Sweep For Framed Shower Doors Easily attaches to the bottom of framed shower doors, using pre-applied mounting tape.
The Deflector and one inch vinyl sweep offer an excellent solution to help deflect water back into the shower enclosure, without detracting from the look of your shower.
Material: Anodized Aluminum
Finish: Bright Chrome
Length: 30 inches
NOTE: Clean adhesion surface with alcohol to remove any oil. Failure to clean surface prior to installation may cause tape to release.
Dad-E
Reviewed in the United States on September 30, 2024
Against some of the reviews I purchased. Although I have prime I had to pay for shipping. Not only did it take almost 2 weeks, it came bent out of shape. Others had same complaint. Therefore, don't buy this. It will be bent out of shape. Waste of 50 dollars
Customer
Reviewed in the United States on July 6, 2024
You may need to cut it to fit your shower if it's older, but it works as intended and the fit is standard. I recommend using a silicone waterproof caulking on the top, because the adhesive is not amazing and not waterproof. It could mold if left unchecked and uncleaned.It's aluminum, so it's very easy to cut on a chop saw.
Ansley B.
Reviewed in the United States on July 17, 2024
Easy to cut, strong adhesive, and cheapest option I found!
MikeM
Reviewed in the United States on May 21, 2024
I had to trim it down to the size I needed with a Dremel. After cleaning the surface and aligning it where I wanted, the application was simple.
BizzeeMe
Reviewed in the United States on November 9, 2024
This was not a good fit for my shower door, it was a bit too long and the flap got caught on the bottom of the shower lip.A bit pricey, found others that were less expensive, but seems made well.
amy bell
Reviewed in the United States on November 15, 2024
Sticker did nothing to hold it on so I used a 5 minute epoxy and glued it on. Doing well 30 days later. Does well at keeping the water in the shower.
Stumpy B
Reviewed in the United States on September 24, 2021
I replace the lip on the shower door that prevents the water from running onto the bathroom floor, this product is very easy to install I am a female and I did this all by myself. I did have to cut about a half inch off the length, I did not have to slope it seeing it is a runoff and not the ones that has a drip catcher. It is super easy to install. The adhesive is super strong, no leaks so far, strongly recommend this product it is the best design that I have seen.
Wilson Elizabeth
Reviewed in the United States on February 1, 2020
I'm a huge fan of great product improvements that solve a problem, and this is line with that. I had a previous piece where the sweep had torn from 20+ years of use. Instead of just replacing the sweep, I went for this complete solution. By installing this item on an angle, it basically diverts all water in the shower to drain into the shower floor and not out through the door. Installation was easy, but there's a caveat. Many reviewers mentioned that it won't hold on its own without using additional adhesive. My finding is that it's not a problem of adhesion, but a problem of packaging. When I removed it from the bag, I noticed it that it wasn't perfectly flat (slightly bent in shipment), so when I placed it on the shower door, the left side adhered fine but the right side pulled off. By clamping the right side with a vise grip and leaving it for a day or more, it held fine, and has been so for over a month now. So my suggestion to the manufacturer is use a corrugate carton for stability instead of a bag. The price point seems like there is enough margin to support the additional expense.Overall I highly recommend this solution. Once you have it in place, clamp both sides and let it cure for at least a day. Also, add a bead of silicone where the top of this meets the shower door and you will have a watertight seal for your shower door, which is a great improvement on the original item, in my case at least.
Recommended Products
