Your cart is empty.
Your cart is empty.The ACDelco GM Original Equipment Brake Pedal Position Sensor monitors the movement or position of the brake pedal to directly activate the brake, brake lights, and turn off cruise control if applied, and is a GM-recommended replacement for your vehicle's original components. This brake pedal position sensor has been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
B.C Customer
Reviewed in Canada on January 21, 2025
Keep in mind you don't always get a code.Often times the cruise control quits or the rear brake lights quit working! That was my case.I have replaced this twice now and the first time it was super tough as the factory put thread sealant on the threads .2nd time a tiny bit easier.So prepare yourself!Best if one could get a battery powered 1/4" drive in there!
Doug
Reviewed in Canada on May 17, 2024
Fast shipping and works great on my Chevy Cruze
tom
Reviewed in Canada on February 17, 2024
Fit and finish was perfect.
Aline G.
Reviewed in Mexico on September 1, 2023
El anterior ya no funcionaba y se encendian los faros al minimo movimiento. Cuando lo sustitui por este sensor se solucionó el problema.
Cep
Reviewed in the United States on May 28, 2023
De exelwnte calidad y esta instalado funcionando perfecto, gracias
Pete. R90
Reviewed in Canada on September 12, 2022
My brake lights had been flickering and coming on by themselves even when pressing the gas pedal. Replaced the brake pedal position sensor and vioala, problem solved.
K. Sizemore
Reviewed in the United States on June 23, 2022
This was for a 2011 chevy cruze. This is not the original one in the car, but it is in fact the updated design to fit that model. Installation sucks. Part works great. Cleared up a check engine light.
ezekiel
Reviewed in the United States on April 9, 2021
Perfect, fixed the problem 2011 Chevy cruze ltz
Mickey W
Reviewed in the United States on September 10, 2020
This brake sensor switch was the solution to fix the check engine light problem. In my case the code for the check engine light specifically indicated that this sensor was the cause for the fault. This was a great savings over purchasing it from the dealership. The hardest part of the installation is getting to the part. The sensor is on the Top of the brake pedal under the dash. So a little twisting and contorting is necessary to install it. One bolt and one plug. Do it yourself at save $$$ over dealership labor. There are some great videos on YouTube to show you how to install it. Don forget to disconnect the battery when replacing the part. Not a hard thing to do but practice getting into the proper position to gain the proper access.
maintman
Reviewed in the United States on August 19, 2019
Wife's cruise control was cutting out intermittently. A google search revealed there was a good chance this little part was the culprit. For $8, it was worth a try. It was difficult to get at, but with a minimum amount of swearing, I got it replaced in about 20 minutes. 1 bolt, and 1 wire connection. Would have taken one minute in an easy to reach spot. In any case, it fixed the problem. I'd call it a win when you can repair a vehicle in 20 minutes for $8!
mrsec46
Reviewed in the United States on September 3, 2018
I like that this part arrived on the specified date. But it was slightly more difficult to install unless you are small in stature and can also contort your body
Melissa M.
Reviewed in the United States on December 25, 2017
Received item broken
Scythe944
Reviewed in the United States on November 30, 2017
Worked perfectly. Finally got rid of my P057C fault code in my '11 Cruze. Should have bought this months ago, took 10 minutes to install.
Recommended Products
