Your cart is empty.
Your cart is empty.Glowshift's 1/8 NPT female to M10 P-1.0 male Adapter. This brass sensor adapter is ideal for oil pressure and fuel pressure sensors that will not thread into your stock port. If you are using this brass sensor adapter for a temperature sensor, a test port sender extender must be purchased since most temperature sensors will not fit through the borehole. It is recommended to use Teflon tape on each thread to prevent any leaks for a secure connection.
STEMaphile
Reviewed in the United States on July 13, 2024
If you are installing a gauge on a vw/audi you need this adapter.
Bryan T Soto
Reviewed in the United States on June 15, 2024
Needed to add an oil pressure gauge to my Audi 2.7T. The GlowShift sender uses NPT threads and everything on this car is metric. This threaded right into the oil pressure port and the sender into this adapter. No leaks and now I have an oil pressure gauge!
Ozy Steiner
Reviewed in the United States on December 2, 2023
Used it for the oil pressure sender on my 5.9 - there is an ORB just above the ECM where this adapter fits.Factory plug is a 5mm Allan. And you need a crow-foot 12mm to seat that adapter. It is doable without disassembly of the ECM but it is tuff. Take your time. Lots of wiring and pipes in the way.
Josh
Reviewed in the United States on January 17, 2022
ITEMS EXCTLY AS DESCRIBED, GOOD SELLER.
Raymond Jick
Reviewed in the United States on January 15, 2020
Did the job
Customer
Reviewed in the United States on August 3, 2019
Fit my application
T P Coombs
Reviewed in the United States on July 30, 2019
Made install EASY :-)
Recommended Products
