Your cart is empty.
Your cart is empty. This fiber glass flight controller anti-vibration shock absorber is compatible with APM Pixhawk KK and MWC .etc flight controller.
Material: Glass fiber
Large Plate Size：100*69*1.5mm
Small Plate Size: 91*61*1.5mm
Weight: 24g
Package includes:
Upper fiber glass plate x 1
Bottom fiber glass plate x 1
Anti-vibration shock absorber x 4
Double tape x 2
Notice:The flight controller does not includes,the main image only for reference.
Thomas J. Coyle III
Reviewed in the United States on February 8, 2024
I have a number of Pixhawk 1s from around 2014 and the vibration pads had melted into green goo from them being stored in my garage. Since I needed just one Pixhawk 1 for a project, I purchased this shock absorber board to mount the Pixhawk 1 on a vehicle chassis and isolate it from road vibrations.The mounting holes for the vibration dampers were slightly smaller in the bottom plate than in the top plate so I used a ream to enlarge them to the same size as the top plate. Installing the vibration dampers in their respective holes was a piece of cake. I looped a long piece of 22 awg wire sequentially through each of the holes, placed the loop of wire over the groove in one end of each vibration damper, and used the wire to pull the grooved end of each vibration damper into its respective mounting hole. Works for both the top and bottom plates.This plate works well isolating the Pixhawk 1's IMU from vehicle vibration as it is intended to do.
beef76
Reviewed in the United States on May 9, 2021
Disappointed when I received this item. I purchased this thinking it was new. This was obviously used prior to me buying it. Full of scratches, scuffs, and was pretty dirty. I expect the products I buy to be new unless stated differently in the description. Ultimately the functionality is fine.
Tom C.
Reviewed in the United States on January 17, 2021
The rubbed shock absorbers are very tight to push into the holes. They rip easily and will not last long attached to these plates.
John
Reviewed in the United States on July 7, 2020
Look closely at the images. Top and bottom cushion holes don't line up at all. Also it is annoying pulling the large cushion through the small holes 8 times. You could easily make something as good as this for under 8.99.
David Bennett
Reviewed in the United States on March 22, 2019
Solved my Pixhawk vibration problem
Customer
Reviewed in the United States on February 27, 2019
Dampens out all the vibrations very good product
Gabriella
Reviewed in the United States on December 24, 2019
Fits my Pixhawk perfectly
Park jong seung
Reviewed in the United States on September 17, 2018
Good
Recommended Products
