Your cart is empty.
Your cart is empty.Fits for Mercruiser Alpha, for Alpha 1, for MR, for bravo's, for OMC cobra's and for Volvo.
Professional Gimbal Bearing Installer Bearing Puller Remover and Engine Alignment Tools Set.
These Tools will be an Indispensable helper when maintance your boat.
Remove/install Gimbal bearings easily.
Shannon
Reviewed in the United States on July 9, 2024
The shaft didn’t fit inside the sheath. It got stuck. The product was poorly made with very little quality control.
Christopher Hunt
Reviewed in the United States on May 21, 2024
Tool is exactly what I need to finish the job, however due to the machining and powder coated finish the rod used to expand the tool to grip the bearing is stuck. After sanding down the piston, it barely fit in the tube and never made it far enough to engage lip of bearing. Now I cant even pound it backwards with a heavy duty punch and a metal hammer. DO NOT BUY!!!
Corey
Reviewed in the United States on November 30, 2024
Wouldn't have gotten the gimble bearing out without it.
Aaron
Reviewed in the United States on October 23, 2024
Quality is better than expected. Only complaint is bearing pulling tool does not come assembled.
Jonathan Carrien
Reviewed in the United States on July 25, 2023
The rod that goes into the puller is to big and won’t fit in. You will have to grind it down to a smaller size in order to get it to fit down the tube. The alignment tool has no hood for the gear guide. You’ll have to drill the hole for the screw to go through to hood it in place so it can be used. It is all made out of heavy duty metal and can take a beating but if you’ll have to do some custom work to get it to work. I didn’t want to waste the time shipping it back.
My
Reviewed in the United States on May 9, 2023
This tool doesn’t work as it should be. The tool parts can’t assembled, it’s a bad design. I’ve to buy it again from different seller, and return this one. Losing my time !!!
Justin D.
Reviewed in the United States on May 14, 2023
Got this tool a few months ago. Finally got around to using it since the weather is nice. The gimbal bearing tool doesn't even go together. The rod that inserted into the main puller can't fit. Super close where I thought it was just the end a bit messed up so I used a hammer to get it started. Now the rod is stuck about an inch in and I'm unable to get it in more or out at all. If they can't get the tools measurements right I don't even want to know the rest of its quality.
tracie ferrero
Reviewed in the United States on December 6, 2022
Missing the hole in the shaft for the installer to go in. Couldn't use it
Recommended Products
$120.99
$ 54 .99 $54.99