Your cart is empty.
Your cart is empty.John
Reviewed in the United States on February 28, 2020
I tried to use them in a fashion they were not intended for, but if I ever get around to constructing kits, they look very good for that application.
thereviewnospinzone
Reviewed in the United States on October 29, 2020
I've had some difficulties placing multiple sets of these next to each other when soldering headers. They seem to be a tiny bit too long so when you try to line up more than 2 end to end then the bottom of the pins no longer line up with the holes.
Kim SN
Reviewed in the United States on February 10, 2019
I make a lot of electronics projects based off the ESP8266-01 which uses a 2x4 pin configuration for connections. Soldering this connector onto a PCB makes installing a removing ESPs much easier.
John V.
Reviewed in the United States on August 28, 2018
I needed these on a PCB that has an Arduino board on it to be able to plug in wireless communication modules (). These allow me to plug in and remove the wireless board from the PCB at will and they worked great for that.
Bloop
Reviewed in the United States on June 13, 2018
Sturdy, and exactly as described. I've soldered dozens with a 40 watt Weller and have never melted one.
Matt Smith
Reviewed in the United States on April 25, 2018
Perfect for ESP-12 modules!
Patrick
Reviewed in the United States on July 27, 2017
Pins are too short. Look very close before you buy.
James M.
Reviewed in the United States on March 31, 2017
good
Recommended Products