Your cart is empty.
Your cart is empty.
TREXFLOW Supply Premium Quality Forward and reverse relay module.
If you have a motor that needs to operate in both directions, this relay module is what you’re looking for.
The Most Common Uses:
- Lift and Tarp applications
- Hoists
- Hatches
- Winches
- Electric Trim Tabs
- Intake/Exhaust Fans and Vents
SPECS:
- WATERPROOF: Sealed, Potted, IP67 rated
- MADE FOR SALTWATER: brass studs and hardware for corrosion resistance
- Runs 70A at 12VDC for Intermittent Loads
- Runs 50A at 12VDC for Continuous Loads
You may also see this module referred to as a Reverse Polarity Module, Motor Reversing Relay Box, or a Forward-Reverse Relay Box. It’s all the same thing!
Brandon
Reviewed in the United States on February 11, 2025
Very nice relay module, exactly as described, and performs as expected.
Christopher Moreno
Reviewed in the United States on September 17, 2024
Replacement part for 2013 Gatortail works great.
kenneth bollinger
Reviewed in the United States on August 12, 2024
If they want put the sate of the dry Contac's with power on the coil put on the add deenergized nc or or energized no that would help i thing . For some that might not know out of the box dry contacts term 30 to 87a nc from 30 to 87 no .
Warren
Reviewed in the United States on May 1, 2024
Wiring diagram shows control switch wired to 12volt +. It should be wired to 12volt-.
Sally Lockhart
Reviewed in the United States on December 9, 2024
I'm building a camper van and I built a lifting bed using four large linear actuators that raise and lower the bed from the ceiling down to couch level. They each draw about 10 amps of current and I need them all to operate at the same time, so I didn't want to just use a switch feeding all of them.This unit is just the ticket. I use a small 12v rated switch to control it and it operates the actuators, reversing the polarity to raise and lower them. It has no problem with the 40 amps of current.The instructions are clear and straightforward, once you get your head around what is going on. One tricky bit is that the control switch operates by grounding one lead or the other, not by applying voltage to them. Once you figure that out it makes a lot more sense.It solves a particular problem and does it well at a fair price, nice piece of kit.
Holliday
Reviewed in the United States on November 19, 2024
Update - posted pics after install and still working great on TH marine outboard jackplate!The unit worked very well for a replacement solenoid on a motor jack plate. All the electrical internals are fully encapsulated and waterproof.
Bcon
Reviewed in the United States on January 13, 2024
The relay works great, I have it installed on a lift table that I fitted with a motor so that the height an be adjusted with a switch. Works great!
Recommended Products
$65.00
$ 29 .99 $29.99