Your cart is empty.
Your cart is empty.Black Ford Oval Logo 2" Inch Trailer Tow Hitch Class III Bar Hole Cover Cap Plug
P Ganev
Reviewed in the United States on August 26, 2024
Fits great and stays on. It is made of high quality rubber.I only hope whoever stole it at the Home Depot parking lot yesterday enjoys it as much as I did!
Michael
Reviewed in the United States on June 20, 2024
Fits perfect - nice and tight. Most likely will not wiggle out over time. Silly that it's so much money for a small piece of rubber, but it does the job probably better than the rest. Looks good and matches the truck well.
Douglas Liebhart
Reviewed in the United States on March 31, 2024
Easy to install hope it holds up in the weather and stays looking good
Rob
Reviewed in Canada on March 18, 2024
Fits great a bit pricey but cheaper than a dealership
Tom J.
Reviewed in the United States on December 28, 2024
Good fit and quality. I followed some of the suggestions on here for securing it with zip ties to help discourage theft. So far it's worked. Highly recommend.
Al
Reviewed in the United States on November 11, 2024
Fits great and looks great. Should keep rain and dirt out.
Bob
Reviewed in the United States on October 6, 2024
New, never used, great price.
DAN
Reviewed in Australia on July 30, 2023
Purchased the trailer hitch cap cover for my vehicle when not towing the caravan or trailer.Its a great accessory that fits snuggly into the trailer hitch receiver, keeping dust, dirt and water out. The trailer hitch cover looks great and fits most trailer hitch receivers.
DM
Reviewed in Canada on September 27, 2022
Fits very snug and looks great
Bob TAYLOR
Reviewed in the United Kingdom on September 1, 2022
The media could not be loaded.
BRIAN
Reviewed in Canada on December 9, 2021
The cap fit my aftermarket hitch on my Ford Edge. It looks GREAT.
Concerned Consumer
Reviewed in the United States on November 14, 2021
Found this here on Amazon for the lowest price I could see anywhere, including e**y. Around $16. So yes, I dinged it for "value for the money." Seriously, $16 (but MUCH more elsewhere) for what's probably a $2 or 3 piece of molded rubber. Ah, yes, but there's the Ford logo. So one pays a premium. It fits perfectly (ought to, it's OEM) and is held on by friction of the rubber against the inside (and outside) metal of the square hitch. I actually did one little mod with the purposes of (a) reducing the chance that it could, over time, come out and (b) discouraging someone from purposefully taking it out and stealing it. I drilled 1/4" holes on the sides of the plug on the interior of the cap (that slides in and holds against the hitch by friction). I then used a couple small screws, nuts and lock washers on each side to secure a couple inch piece of metal hanger tape (the kind you use to secure plumbing pipes) on each side. This is (a) flexible, (b) cheap and I had some around anyway, (c) lightweight and (d) has holes already in it. I'd arranged it so that the holes in the tape match perfectly with the holes on the sides of the hitch. Through the holes in the hitch I threaded an 11" black zip tie (UV resistant/indoor/outdoor) then through the holes it the hanger tape. Zipped it up on top and cut off the excess tie material. No, it's not as secure as a lock, but then again it didn't cost $20 or so. There's no way the cap will work its way loose now and sure, someone could cut the zip tie and still take the cover, but I think that it's sort of like a door lock. There's no door lock made that can keep a determined crook from getting into your house. Your goal is to make it cost time and effort so that the crook will go somewhere else. If someone just tries to pull it off, it isn't going to just pop off. Then they're going to have to look around it so see what's holding it on, then they've got to have a knife or a pair of wire cutters. Then they're going to have to cut it, etc. So sure, not perfect, but a deterrent that cost me a few pennies and not even 5 minutes to set up. Hope that helps someone! I paid full price with my own money, so this is my honest review without influence of payment.
W. Lerner
Reviewed in the United States on February 19, 2016
This trailer hitch cover fit perfectly into the factory hitch of my 2015 Ford F-150 Platinum. The rubber is thick and the hitch cover appears to be well made. The cover is flexible enough to allow for easy insertion into the hitch, and solid enough that you can feel confident it will not slip out. The cover completes the look of my truck when viewed from behind.Recently the weather turned cold (~20 degrees F). The hitch was still flexible and easy to insert and remove. I highly recommend this inexpensive finishing item for your factory trailer hitch equipped Ford vehicle. I would purchase this item again.
Recommended Products
