Shopping Cart

Your cart is empty.

Your cart is empty.

Folding Tool Steel Metal Bending Tool Sheet Metal Bender for HVAC Bending Forming 3/8 and 1 Fold Depths in Ductwork(24 Inch)

4.7 (8) Write Review
Free shipping on orders over $29.99

$28.99

$ 12 .99 $12.99

In Stock

1.Size:12 Inch


  • 12 Inch Design: the package contains 1 piece of metal folding tool, about 12 inch in length, which is fit for bending and forming steels within 12 inch long; Please make sure the size if you need before purchasing
  • Strong and Sturdy: the folded seam of the metal panel hemming tool is formed by 2 pieces of heavy duty 16 steel halves, which are connected together tightly, not easy to break, solid enough, serving you for a long time
  • Curving Range: the sheet metal bender tool can be bent up to 0.05 inches/ 1.2 mm galvanized sheet, 0.01 inches/ 0.3 mm cold roll steel sheets and stainless steel, bringing you a lot of convenience
  • Simple to Use: the hole of the sheet metal hand tool allows you to observe and to ensure the correct depth alignment, which can be applied to fold and bend metal, applicable for making seams and edges
  • A Wide Range of Applications: the metal bending tool is suitable for various occasions, which can create 3/8" and 1" folding depth in ductwork, fitting metal roof working, construction, HVAC working and more



Features:
Simple to take along:
The sheet metal tool is portable and handy, easy for you to carry when you go outside to work.
Warm using tips:
The end of the metal hemming tool is not quite polished.
Specifications:
Main material: heavy duty 16 steel halves
Color: black gray
Size: about 12 inch in length
Package includes:
1 x Metal bending tool
Notes:
Manual measurement, please allow slight errors on size.
The color may exist a slight difference due to different screen displays.


Marlen
Reviewed in the United States on March 6, 2025
Muy bien el precio y la calidad
Skylar Kelly
Reviewed in the United States on February 26, 2025
Works great as a small break on the job site
Mark Stephen
Reviewed in the United States on March 5, 2024
This product is constructed well with sturdy metal. I used it to make rain and weather barriers from thin sheet metal for exterior security cameras. The barriers act like a small roof. The sheet metal I used needed to be bent at 90 degrees for installation above cameras. The small bend is where the barrier was mounted with screws. This tool produced neat bends, much nicer than using hands and a board or vise. Highly recommend and should last a lifetime. Recommend!
Julian Etheridge
Reviewed in the United States on December 29, 2024
They look great easy to put on fast shipping thank you!!
Brian
Reviewed in the United States on November 2, 2024
Good for making 1” flanges, ears for drives, 1/2” flanges, I have like 10 of these things. Also great for fabrication of duct on site, when you have wrong or missing pieces. They are tough and durable to a point, but there is definitely a limit to the abuse they can tolerate. But these are solid tools. Item as described, arrived quickly. Wddbwa.
Critter Gitter
Reviewed in the United States on October 7, 2024
This is great for making hems in coil stock, and applying the material to structures to keep critters out.
Gary Boston
Reviewed in the United States on October 30, 2024
This is just as it is described and the tool I wanted.
A. Mancheski
Reviewed in the United States on October 14, 2024
Purchased this to replace my well used malco that has got beaten up over many years of use. Besides being noticeably heavier than my other Malco brand of same size does just as well for a much lower cost.