Your cart is empty.
Your cart is empty.Product Description
Fit for Lathe Swing Diameter 13 - 18"
CXA Quick Change Tool Post Holder
- 250-301 Tool Holder- Securely holds 1/2" - 3/4" square tool bits.
- 250-302 Tool Holder- Use tool bit up to 3/4" and round shank tool bits up to 3/4".
- 250-304 Tool Holder- Holds 3/4" tool with bushing, 1" diameter without bushing.
- 250-307 Tool Holder- Use 3/4" high parting blades,blade width 3/16"; 2" overall height.
The quick change tool holder has undergone quenching treatment, with high hardness and is not prone to vibration. The surface is finely ground, smooth and flat, with high accuracy.
Completely sealed, no maintenance operation required. Turning and facing tools can be locked together (saving time and labor when changing operations).
Jason R.
Reviewed in the United States on December 9, 2024
Very nice product
RJ
Reviewed in the United States on January 5, 2024
I will order these again because they replaced defective ones without problem.Two of the total of ten I have gotten had the height adjustment thumb-nut threaded not perpendicular (5+ degrees off) with the nut surface. That results in the nut wobbling as you turn it. Not useful. Fit on the CXA holder is a bit loose but works OK. As mentioned, if tight tolerances are needed, maybe buy a name brand at a much higher price. More than fine for hobby work though where I can touch off the tool to ensure depth is right each time a tool is changed.Maybe unfair at this price point but I gave it 3 out of 5 assuming that a "perfect" tool holder would be 5 of 5 and because of the thumb-nut problem.
Juan DeSantiago
Reviewed in the United States on August 8, 2023
Does the job
tauffers
Reviewed in the United States on June 30, 2023
It's cheap! It works well! Notibly more slope before caming things down tight. Your setup may vary but I'll buy again.
Charis Group
Reviewed in the United States on February 27, 2023
Love the quick change capability. Just tool up, align with the center and cut. Put away until next time.
Customer
Reviewed in the United States on October 22, 2023
Tool holder fit perfect, screws were better than most other brands. Great product for the price.
COrtega
Reviewed in Mexico on April 24, 2022
Me encantó el precio, el producto es funcional
C. Brown
Reviewed in the United States on June 22, 2021
This CXA is completely compatible with Aloris CXA quick change tool posts. The mating surfaces are ground perfectly, This holder is satisfactory in all respects.
D Boyd
Reviewed in the United States on September 1, 2020
Got one of these to try out before ordering more. Finish is quite good, finely ground wedge faces. I have an Aloris CXA toolpost, and the fit is a bit looser than a real Aloris tool holder, but still tightens up fine. As many have stated, the clamp screws are a bit of a loose fit, so I'll probably replace those, but for 1/4 the cost of Aloris or Dorian, well worth it, IMO.
Recommended Products
$14.99
$ 6 .99 $6.99
$35.99
$ 15 .99 $15.99