Your cart is empty.
Your cart is empty. 13-Hole mounting pickguards with no notch to accommodate truss rod. Cut for single Precision Bass® pickup. No holes drilled for vintage-style thumb rest or pickup cover.
Fits American Series/Standard/Vintage (USA), Standard and Deluxe Series (Mexico) models. Will not fit 5-string Precision Bass®.
David ladd
Reviewed in the United States on August 17, 2024
As you expect it came from fender so its nice and fits well but i have had just as much luck with musiclily
J. Portillo
Reviewed in the United States on July 24, 2024
This thing is dope. It looks more beautiful than the cheaper knock offs. I just wish it fit my bass. Be warned if you have a 90’s MIM P Bass with upgraded Seymour Duncan’s it will have a hard time fitting around the pickups and the input jack isn’t quite lined up.
Jeremy
Reviewed in the United States on May 20, 2024
This item is miss listed as fitting US built Fender P-bass but it will only fit the made in Mexico P-bass.
Ron S
Reviewed in the United States on May 13, 2024
Fits my Players Series Precision Bass perfectly.
タカ猫
Reviewed in Japan on November 19, 2024
fender American professionalⅡにジャストフィットしました。加工もなくピックガードのソリや汚れも全くありませんでした。当然ビス穴も問題ありません。安いピックガードを買うと、何かしらありますが、これは何の問題もありません。パール柄も良い感じで高級感があり、100点満点です。
Mark Garrisi
Reviewed in the United States on August 3, 2023
All holes mated up perfectly. The boys approved.
Wldb
Reviewed in the United States on December 12, 2023
It is by fender you won’t be disappointed,
jeff
Reviewed in Canada on November 6, 2023
Purchased to change the look of my 75th Anniversary Commemorative
Customer
Reviewed in the United States on March 11, 2016
Nice guard. Has the notch for heel truss adjustment.
JdoubleH
Reviewed in the United States on March 31, 2013
Not only does it look great, but it was a direct fit- perfect screw and neck fit. That was a pleasant surprise, as it is common to have to fill a hole or two (wood glue and a toothpick works, let it dry, trim it off flush with a sharp knife) and re-drill one or two screw holes. It IS very tight on the pickup covers. But I had removed them and filled mounting screw holes prior to doing some refinish work on the body, so when mounting the pick guard, I squeezed the pickups in a bit high, and then added the pickukp screws after I had the guard fully mounted and I had the bass strung. That way, I just needed to lower them to the desired height. Raising them may require removing the pick guard screws, even with the healthy stacking of weatherstrip foam under them.The pack guard is fully shielded over the entire pickup / control route, not just the control cavity like the allparts ones.
Recommended Products
$28.49
$ 14 .99 $14.99