Your cart is empty.
Your cart is empty.FelPro gaskets offer 100% vehicle sealing with applicationspecific materials to give you sealing solutions with the performance and durability professionals trust
chris
Reviewed in the United States on March 3, 2025
This valve cover gasket performed exceptionally well during installation on my 2013 Kia Optima SX-L Turbo. The gasket fit snugly within the grooves and remained securely in place throughout the valve cover reinstallation. Long-term durability remains to be assessed, however, no oil leaks have been observed to date.
Chad
Reviewed in the United States on February 11, 2025
Perfect fit
Jason h.
Reviewed in Canada on February 11, 2025
Did not fit my 2.4 gdi motor
MandiDC
Reviewed in the United States on January 7, 2025
Worked out well for my 2011 Kia Sorento LX FWD. Fit as expected.
Larry Welch
Reviewed in the United States on March 10, 2024
Installed this on my parents 2013 Sorento, it was a perfect fit. No more oil leak. Cleaned both mating surfaces first, and put a little bit of black rtv sealant in the gasket seat to hold it in place while reinstalling the valve cover. The job took about an hour.
jin woo lee
Reviewed in the United States on December 5, 2024
Even Amazon "Fit" this item to my car but too big as shown photos. I cut it out and put in black sealant and install it.There comes with fuel pump gasket but my car do not have fuel pump at the top of the engine.So this is not for 2010 hyundai sonata 2.4l .Check it out before you order.
Scott G. Stark
Reviewed in the United States on November 3, 2024
The hardest part is removing the valve cover. Replacing gasket was simple and this fit tight and perfectly. Once installed the minor leak has been resolved. Also came with separate fuel gasket that since I was into it replaced it also. Cheaper than auto stores and worked perfectly. Highly recommend.
ImEdD
Reviewed in the United States on October 26, 2024
perfect fit , no leaks after watching youtube videos lol, diy all the time, its not hard to change it, save money , and learn new things
Allan Aguilar
Reviewed in Canada on September 13, 2023
This is the first time for me to use this brand in replacing a valve cover gasket. This specific item fits without any hitch on my 2012 Hyundai Sonata 2.4 ltr. Just remove the valve cover according to the repair manual, clean the mating surfaces of the cylinder head, and apply some RTV silicone sealant on the joints near the timing chain. Clean the internal and external part of the valve cover and install this gasket. Carefully install the valve cover, install the bolts and torque them according to specs and you're good to go.Just a side note, also replace the O-ring of the high pressure GDI pump before re-installing the pump. I used Fel-Pro 71857 Multi-Purpose O-Ring.
Alvaro
Reviewed in the United States on October 5, 2023
Product was fine overall for the money but in a couple of sections the sealing surface was a bit rough, I had to add some RTV on it. Also, there is a small section that does not match the profile of the cover for my 2.0T Santa Fe (a section going around a screw on the left side), so I had to force it to stay in place while tightening the screws
James M.
Reviewed in Canada on July 8, 2022
I haven’t installed yet. Product looks to be OEM correct.
Recommended Products
$36.19
$ 16 .99 $16.99