Your cart is empty.
Your cart is empty.With over 25 years of experience in aftermarket suspension design. State of the art software, fabrication equipment along with our seasoned engineers and fabricators allow the company to develop products that are constantly on the cutting edge. Fabtech leads the industry with extensive research, design technology and rigorous testing that results in the highest performing, finest quality suspension system for the discerning offroad enthusiast
Christian King
Reviewed in the United States on July 30, 2020
Esto 😔 no es lo que están ofreciendo.
JRL
Reviewed in Canada on July 22, 2019
These are just the tie rod end that is designed to fit a 6” basic Fabtech lift with performance shocks, kit number K3053. These tie rod ends are designed for the Dodge/Ram1500 Trucks.These are shorter than stock and WILL NOT FIT STOCK KNUCKLES and are required with that specific lift kit which come with FT Knuckles.Another part number is the FT44066 Which will Be on the actual tie rod inside the box. It’s only one tie rod end per order.Hope this helps.
Brian J. Auer
Reviewed in the United States on July 4, 2014
These tie rod ends are intended to go with the Fabtech lift kit. Mine is a 2006 Ram with a 6" lift. The stock tie rod ends are smaller and longer, so these are different and not interchangeable. Good construction and quality. Had a bit of a problem with one of my new ones -- threads were very tight and I had to put it on with a pipe wrench. Also, the picture here is not representative of the product. It's only the tie rod end and they do not look like that.
Awahlm88
Reviewed in the United States on May 24, 2014
I can tell this is a very well built tie rod end unfortunately it does not fit my 2007 Dodge ram 1500 4WD. even though it says it does. I believe this is the tie rod end for the Mega cab model since it is a different suspension setup in the front. I would return them if not for the fact that I started installing them before realizing that they were the wrong ones.
Recommended Products
